Laserfiche WebLink
VOICE & DATA COMMUNICATIONS <br />Section 16760 <br />15-1207 <br />G. All fibers shall be tested and certified and results submitted to MUSD IT. <br />H. All warranties for fiber should be submitted to MUSD IT. <br />Table 6. Fiber Specification <br />Purpose <br />Make <br />Model <br />Part Number <br />MDF Fiber Panel <br />I Panduit <br />Panduit 19" Rack Mount Fiber <br />FRME4 <br />Encl. <br />IDF Fiber Panel <br />Panduit <br />Panduit 19" Rack Mount Fiber <br />FRME1 <br />Encl. <br />Backbone Fiber Cable <br />Berk- <br />Plenum Indoor/Outdoor S/M <br />LTP012-AB0504 <br />Tek <br />Fiber Optic Cable <br />LC Bulkhead <br />Panduit <br />Panduit LC Bulkhead Single <br />FAP12WBUDLCZ <br />Mode Duplex Ports <br />Fiber Optic connectors <br />Berk- <br />Single mode Fiber optic <br />10062630 <br />Tek <br />connector <br />Fiber Patch Cables <br />LC/LC Single mode Duplex <br />Fiber Patch Cable <br />2.6 GENERAL CATEGORY 6 AND 6A SPECIFICATION <br />A. See able 7 for make, model, and part numbers for cabling, panels, faceplates, and jacks. <br />B. Category 6 cabling shall be used for all data, VoIP phones, and IP clocks/speaker locations. <br />C. Category 6A cabling shall be used for all ceiling locations for wireless access points. <br />D. Standard classroom cable count is a total minimum of seven (7) jacks. <br />i. Category 6 cables shall be a total of flue (5) jacks. Two (2) jacks on one Wali and iWv (2) <br />jacks on an opposite wall, and one (1) cable for IP clock/speaker location. <br />2. Category 6A cables shall be a total of two (2) jacks located at the center of each <br />classroom/room. <br />E. Classroom workrooms has two (2) wall jacks per workstation locations. <br />F. Administration general office areas cabling location and quantity is based on site's requirements. <br />G. Administrators/counselors offices has a total of four (4) wall jacks, two (2) jacks on two opposite <br />walls. <br />H. Kitchen office has a total of two (2) jacks on one wall. <br />Caddy "J" hooks shall be installed every 5 feet above suspended ceiling to support all cabling. <br />All cabling should be properly secured and not attached to the support wire of the T -bar ceiling <br />and not laying across ceiling boards/tiles. <br />All copper cabling shall be installed away from electrical interference. <br />K. Horizontal cabling at station location should have a service loop of 6' above ceiling. <br />8 <br />