WORK PLANS - Laserfiche WebLink

Home Browse Search

0 N Gi A F+ IR N 4 PLUMBING SCHEDULE PLUMBING DESCRIPTION PLUM. NO. ITEM. NO. DESCRIPTION QTY.CO TER WA. SIZE HGT,* C.W. H.W. WALL WASTE �SIZE FEGT.0 ®IR . INDIR. WALL BTU HR GAS . FIGT. x1, 00 SIZE WALL REMARKS NOTE(S) P1 - FLOOR SINK SEA. — M-. DIR. WASTE (DIRECT CONNECTION) +O" 0 L_°J SHEET AND/OR KEY NOTE INDIR. INDIRECT WASTE (AIR GAP) INSTALL FLUSH WITH FINISH FLOOR, PROVIDE GRATE COVER W/ DOME STRAINER, REFER TO PLUMBING PLANS FOR TYPE AND SIZE. >10 P2 2 WALK—IN FREEZER GOND. DRAIN FROM COIL CONN. + 70" 1 _ — W.C. — 1 „ 1" INDIRECT DRAIN TO F. P1. SLOPE 1/2" PER FOOT PROVIDE 1" MIN AIR GAP AT F.S WITH 'P" TRAP. SHUT OFF VALVE (S.O.V.) P3 3 WALK—IN REFRIGERATOR COND. DRAIN FROM1" COIL CONN. + 70" 1 EA. — — .� — 1 — `� GENERAL CONTRACTOR .� — INDIRECT DRAIN TO F.S P1. SLOPE 1/2" PER FOOT PROVIDE 1" MIN AIR GAP AT F.S WITH "P" TRAP. K.E.C. KITCHEN EQUIPMENT CONTRACTOR 5 WALL MOUNTED HAND SINK FAUCET W/ 1/2- INLET 4 CENTER 2� 1/2- 1/2- 1 B„ 1 1/2- -- 24„ _ � � _ PROVIDE S.O.V., RUN PIPING TO UNIT CONNECTION. RUN DIRECT WASTE WITH P -°-TRS. GALLONS PER HOUR P5 B POTWASH SINK FAUCET W/ 3/4" INLET B" CENTER 2EA. 3/4" 3/4" 16„ — 2" — �— GAS INLET �. PROVIDE S.O.V., RUN PIPING TO UNIT CONNECTION. PROVIDE 2 INDIRECT DRAIN TO F.S P1. (CHROME OR PAINT SILVER) P6 B PRE—RINSE & FILL FAUCET, SPLASH MOUNTS FAUCET W/ 1/2 INLET B CENTER 1 EA. 1 /2" 1/2" 16" .. — .. � _ _ � PROVIDE S.O.V., RUN PIPING TO UNC(' CONNECTION. PROVIDE 2 INDIRECT DRAIN TO F.S P1. (CHROME OR PAINT SILVER) P7 12 PREP SINK" „ FAUCET W/ 1/2 INLET Z3 CENTER 1 EA. — 1 2" / +16" -� 2" — �. _ PROVIDE S.O.V., RUN PIPING TO UNIT CONNECTION. PROVIDE 2 INDIRECT DRAIN TO F.S P1. (CHROME OR PAINT SILVER) P6 15 DOUBLE STACK CONVECTION OVEN 2EA. — — -- — — _ 120 3/4„ 16" PROVIDE S.O.V., RUN PIPING TO UNIT CONNECTION MANIFOLD FOR TOP OVEN TO BOTTOM OVEN BY MFG. NATURAL GAS. P9 P10 P11 P12 P13 PLUMBING NOTE(S): 0) PROVIDE INSULATION FOR FULL LENGTH OF DRAIN LINE OVER HEAT TRACE (FREEZER) FIRE SYSTEM NOTE: 1. FURNISH AUTOMATIC GAS SHUT-OFF VALVE INCLUDING ANY NECESSARY ACCESS PANEL. CONTRACTOR SHALL INSTALL THE AUTOMATIC SHUT—OFF VALVE IN AN ACCESSIBLE LOCATION. REFER TO PLUMBING DRAWINGS FOR GAS VALVE LOCATION. SCALE : 1/4" x T-0" r REQUIREMENTS 1. — PLUMBING CONTRACTOR TO VERIFY ALL INCOMING SERVICE AND MADE FINAL HOOK—UPS TO ALL APPLICABLE EQUIPMENT AND TO PROVIDE ALL PIPING, TEES, I=LLS, TRAPS, FILTERS, REGULATORS, FAUCETS, ETC., UNLESS SPECIFICALLY STATED OTHERWISE. 2. — ALL HORIZONTAL DIMENSIONS SHOWN ON PLAN ARE FROM FINISHED FACE OF WALL TO CENTERLINE OF STUB—OUT OR FROM CENTERLINE OF STUB—OUT TO CENTERLINE OF STUB—OUT, UNLESS NOTED OTHERWISE ON PLAN OR DETAIL. (VERIFY ALL DIMENSIONS) 3. — SYMBOL NOTED +24% +48", ETC., INDICATES TO STUB- OUT OF WALL AT HEIGHT INDICATED. HEIGHT IS GIVEN FROM FINISHED FLOOR (NOT FINISHED CURB) TO CENTERLINE OF STUB—OUT. SYMBOLS INDICATED "STUB—UP„ AND "STUB—DOWN" ARE TO EXTEND ABOVE FINISHED FLOOR AND/OR BELOW FINISHED CEILING AT LOCATION SHOWN. 4. — PLUMBING STUBS AND CONNECTIONS SHOWN ON PLANS ARE FOR EQUIPMENT FURNISHED BY THE FOOD SERVICE EQUIPMENT CONTRACTOR. 6. — FLOOR SINKS SHOWN ARE TO BE SET FLUSHED WITH TOP OF FINISHED FLOOR. FLOOR SINKS INDICATED HALF—IN AND HALF—OUT OF EQUIPMENT TO BE SET FLUSHED WITH TOP OF FINISHED FLOOR. FLOOR SINKS LOCATED COMPLETELY WITHIN EQUIPMENT AREA TO BE SET FLUSHED WITH TOP OF FINISHED FLOOR. 6. — PLUMBING CONTRACTOR TO PROVIDE AND INSTALL REMOVABLE COVERS OR GRATES FOR ALL FULLY LIR PARTIALLY EXPOSED FLOOR SINKS. GRATES TO HAVE 1/2* MAX OPEN"GS WHERE DRAIN IS EXPOSED TO P.O.T OR TO PEDESTRIAN WAYS TYP. 7. -m PLUMBING CONTRACTOR SHALL SEAL ALL PLUMBING PENETRATIONS THROUGH WALLS, FLOORS, AND CEILINGS. WATERTIGHT AND VERMIN—PROOF. 8. — PLUMBING CONTRACTOR TO PROVIDE AND INSTALL SHUT-OFF VALVES ON ALL WATER AND GAS LINES, INCLUDING VALVES IN FIXTURES, LOCATED IN SUCH A WAY AS TO BE ACCESSIBLE WITHOUT USE OF TOOLS. 9. — PLUMBING CONTRACTOR TO PROVIDE AND INSTALL FOR ALL APPLICABLE EQUIPMENT, A TRAPPED FLOOR SINK WITH A LEGAL AIR GAP DRAIN LINE (INDIRECT WASTE) TO FLOOR SINK. INSULATE ALL DRAIN LINES FROM ICE BINS, ICE MACHINES, REFRIG. EQUIP., ETC.. CONDENSATE DRAINS FROM COILS TO BE FURNISHED AND INSTALLED BY PLUMBING CONTRACTOR PROVIDE HEAT TRACE W/ INSULATION FROM COIL TO DRAIN (FREEZER) 1�1 GAS SHUT—OFF VALVE FOR ANSUL SYSTEM WITH ACCESS DOUR VERIFY LOCATION WITH PLUMBING DRAWINGS GRATE VIEW SECTION FLAN VIEW NOTE: E: FLOOR SINK DETAIL IS FOR REFERENCE ONLY. FOR FLOOR SINK TYPE AND SIZE REFER TO PLUMBING PIANS. gai Glit : f o ° t 1. arch"tects yam} r ,Mr i CAPITAL ENGINEERING CONSULTANTS, I NC. FLUSH FLOO r% '""INK DETAIL r2 11020 SUN CENTER tart. STe.100 RANCHO CoRgova, CALWORNIA 9i8.Rbc.350,�500lwxrw.capital-s�lginee�rtn�.c©m AMD 150605-00 SCALE : NONE • � � ►,, ADREVIATI{ N--1 PLUMBING DESCRIPTION PLAN LEGEND SYMBOL DESCRIPTION C.W. COLD WATERPLUMBING SCHEDULE REFERENCE, f,1 REFER TO F a2.Q.G FOR SCHEDULE H.W. HOT WATER DIR. WASTE (DIRECT CONNECTION) 0 L_°J SHEET AND/OR KEY NOTE INDIR. INDIRECT WASTE (AIR GAP) >10 COLD WATER INLET LAV. LAVATORY HOT WATER INLET' W.C. WATER CLOSET �— SHUT OFF VALVE (S.O.V.) F.S. FLOOR SINK P.C. PLUMBING CONTRACTOR Of>+ COLD WATER SHUT OFF VALVE G.C. GENERAL CONTRACTOR ! I GAS SHUT-OFF VALVE K.E.C. KITCHEN EQUIPMENT CONTRACTOR FLOOR SINK S.O.V. SHUT OFF" VALVE FLUOR DRAIN GPH GALLONS PER HOUR PSI POUNDS PER SQUARE INCH WASTE DOWN (F) DEGREES FAHRENHEIT GAS INLET CONN. CONNECT WALK—IN DRAIN LINE LOC. LOCATE I.D. DRAIN LINE Copyright a 2013 Rainforth Grau Architects. All rights reserved. Reproduction of these pians, either in whoie or in part, including any form of copying and/or preparation of derivative works thereof, for any reason without prior written permission, is strictly prohibited. APPROVAL MAINTECA UNIFIED SCHOOL DISTRICT E Emig I will ■ its 0 Revision DRAWN AMD CHECKED AICD SCALE As indicated PROJECT NO. 15-1207 DATE 0f-26-15 SHEET FS2■0.®