WORK PLANS - Laserfiche WebLink

Home Browse Search

ASBESTOS ABATEMENT -- ROOFING Section 02082 15-1207 B. Appropriately labeled, closed, impermeable drum containers. C. Bilingual labels (English and Spanish) on containment glove bags, waste packages, contaminated material packages and other containers shall be in accordance with EPA or OSHA standards. 2.02 WARNING LABELS AND SIGNS A. As required by 29 CFR 1926.58 and 29 CFR 1910.145. 2.03 PERSONAL PROTECTIVE EQUIPMENT A. Personal Protective Equipment shall comply with the requirements of 29 CFR 1910, Subpart I. B. Work clothes shall consist of fire retardant, disposable, full-body coveralls, head covers, boots, rubber gloves and sneakers or equivalent in accordance with 29 CFA 1926.58, and ANSI Z41. Sleeves at wrists and cuffs at ankles shall be secure. C. Eye protection and hard hats shall be available as required by applicable safety regulations and shall conform to ANSI 87.1 and 89.1. D. Provide authorized visitors with suitable protective clothing, headgear, eye protection and footwear whenever they are required to enter Work area. 2.04 RESPIRATORS A. Provide all workers, foremen, superintendents, authorized visitors and inspectors personally issued and marked respiratory equipment jointly approved by NIOSH/MSHA. When respirators with disposable filters are employed, provide sufficient filters for replacement as recommended by manufacturers or this Specification. Selection of respirators shall be made according to the guidance of 29 CFR 1910, Subpart 1; ANSI Z88.2; CGAI G7.1; EPA 560 OPTS -86-.001. B. When positive pressure supplied air Type "C" equipped with full face piece respirators are employed, the Air Supply System shall provide Grade "D" breathing air in accordance with OSHA 29 CFR 1910, Subpart I and ANSI Z88.2 and CGAI G7.1. C. The Compressed Air System for Type "C" Respirators shall be high pressure (nominal 100 psi), with a compressor capacity to satisfy the respirator manufacturer's recommendations. The receiver shall have sufficient capacity to allow a 15 minute escape time for the respirator wearers in the event of compressor failure or malfunction. Type C supplied air respirators with HEPA filter disconnect may be used as an alternate to the 15 minute escape time required with event of compressor failure for Type C respirators. The Compressed Air System shall have compressor failure alarm, high temperature alarm, carbon monoxide alarm, and suitable in-line air purifying sorbent beds and filters to assure Grade "D" breathing air. D. The minimum respiratory protection required for this project is as follows: Use half face mask air purifying respirators approved for asbestos in case the removal