WORK PLANS - Laserfiche WebLink

Home Browse Search

CHAIN LINK FENCES & GATES Section 02444 15-1207 a. To 8'-0" high maximum: 2-3/8 inch o.d. pipe at 3.65 lbs. per lin. ft. b. 8'-1" to 10'-0" high maximum: 2-7/8 inch o.d. pipe at 5.79 lbs. per lin. ft. D. End, Corner and Pull Posts: Without Slats or Windscreen: a. To 8'-0" high maximum: 2-7/8 inch o.d. pipe at 5.79 lbs. per lin. ft. b. 8'-1" to 10'-0" high maximum: 4 inch o.d. pipe at 9.11 lbs. per lin. ft. E. Gate Posts (single leaf): To 6 ft. wide: 2-7/8 inch o.d. pipe at 5.79 lbs. per lin. ft. F. Top rail and braces: 1-5/8" o.d. pipe at 2.27 lbs. per lin. ft., or 1-5/8" x 1-1/4" roll formed section, 14 ga. Brace Assembly: Brace shall be equally spaced between top rail and bottom fabric selvage and run from end, gate, or corner post to first line posts with suitable malleable iron fittings. Truss from line post to end, gate, or corner post with 3/8" round rod. G. Tension wire: 7 ga. coil spring wire. H. Gates: 1. Frames: 1-5/8" o.d. pipe at 2.27 lbs. per lin. ft. for gate leaves to 6' wide; leaves over 6' wide, use 2" o.d. pipe at 2.72 lbs. per lin. ft. Provide additional horizontal and vertical pipe or tube as necessary to assure proper gate operation and attachment of fabric and hardware. 2. Diagonal bracing: Provide crossed diagonal adjustable length 3/8 truss rods on all non -welded gate frames and welded gate frames where corner rigidity is insufficient to insure no sag. 3. Fabric: Same as specified for fence. 4. Gate assembly: Weld or assemble gate frame with malleable or pressed steel fittings and rivets to provide rigid connections. Install fabric with stretcher bars at vertical edges, which may also be used at top and bottom edges. Securely attach stretcher bars and fabric to frame on all sides at 15" o.c. Attach hardware with rivets or by other means which will provide security against removal. Gate hardware: 1. Hinges: Malleable iron, pressed or forged steel, non -liftoff type, easy noiseless operation and long wear, offset to permit 180 degree gate opening. Ball and socket hinges not acceptable. Provide 1-1/2 pair hinges for each leaf over 6' nominal height. 2. Latch: Malleable iron, drop fork latch which permits operation of the gate from either side, with padlock eye provided as integral part of latch. At gates which are required to receive panic hardware or lever locksets, provide all necessary galvanized iron lockset boxes, backing plates or mounting plates as required for permanent, vandal resistant mounting. All hardware must be disabled accessible as defined by and mounted per the requirements of the CBC. 3. Gate stop and holder: Malleable iron for vehicle gates. Provide stop that automatically engages gate frame and holds it in open position. 3