WORK PLANS - Laserfiche WebLink

Home Browse Search

MISCELLANEOUS METALS Section 05110 15-1207 assembly or erection shall be given two coats of specified primer, second coat darker in color. 3.03 FABRICATION A. Miscellaneous framing and supports: 1. Provide miscellaneous steel framing and supports which are not part of structural steel framework, as required to complete work. 2. Fabricate miscellaneous units to sizes, shapes and profiles shown; or if not shown, to require dimensions to receive adjacent other work to be retained by framing. 3. Fabricate the miscellaneous units from structural steel shapes, plates, and steel bars of welded construction with mitered joints for field connection, unless shown otherwise. 4. Cut, drill and tap units to receive hardware. 5. Equip units with integrally welded anchors for casting into concrete or building into masonry, and furnish inserts if units must be installed after concrete is placed. 6. Except as otherwise shown, space anchors 24" on center, and provide minimum anchor units of 1-1/4" x 1-1/4" x 8" steel straps. 7. Galvanized miscellaneous frames and supports where indicated. 3.04 ERECTION A. Preparation: Furnish setting drawings, diagrams, templates, instructions and directions for installation of anchorages, such as concrete inserts, anchor bolts, and miscellaneous items having integral anchors, which are to be embedded in concrete construction. Coordinate delivery of such items to project site. B. Install miscellaneous metals and accessories in accord with reviewed Shop Drawings, referenced standards, manufacturer's installation recommendations or as directed by Architect. C. Field Welding: Comply with AWS Code for procedures of manual shielded metal arc welding, appearance, and quality of welds made and methods of correcting welded work. D. Installation: Fastening to in-place construction: Provide anchorage devices and fasteners where necessary for securing miscellaneous metal fabrications to in-place construction including threaded fasteners for concrete inserts, toggle bolts, through -bolts, lag bolts, wood screws and other connectors as required. a. Adhesive anchors shall only be used at concrete block only and only at locations where detailed. 2. Cutting, fitting and placement: a. Perform cutting, drilling and fitting required for installation of miscellaneous metal fabrications. b. Set work accurately in locations, alignment and elevations, and make plumb, level, true and free from rack, measured from established lines and levels. C. Provide temporary bracing or anchors in formwork for items which are to be built into concrete or similar constructions.