WORK PLANS - Laserfiche WebLink

Home Browse Search

METAL DOORS & FRAMES Section 08100 15-1207 O.C. max.) aligned with hinge and strike locations. Coordinate installation of anchors and grouting of frames with other trades. 3. At all exterior wall locations where frame is installed in a wall with a concrete curb base, fill the bottom void of the frame with non -shrink grout to match the height of the concrete curb. Repair all frame modifications to a blemish free new condition. Do not cut or modify the frame if it conflicts with the concrete curb. If concrete curb conflicts with frame, adjust or modify curb as required." 4. Anchor to floor slab with powder type actuated fasteners through floor anchors attached to frames. 5. Anchor securely to metal studs with four (4) No. 12 sheet metal screws per anchor. 6. Anchor continuous nailing flange securely to wood studs with four (4) No. 12 x 2" flat head wood screws per anchor. Attach anchor straps at interior side and all interior straps with four (4) 10d ring shank nails per anchor. 7. Seal perimeter of frames to fill space between frame and adjoining material. Seal all exterior, exposed fastener heads to make waterproof. Sealant materials and application shall conform to applicable requirements of Section 07900. 8. When installing new frames in existing openings, remove existing finishes sufficiently to properly install and adequately fasten new frame. Prepare openings as required to receive new frame. Provide misc. shimming, blocking, backing, straps, etc. to fully prepare opening for new frame. Patch and repair surfaces when completed to match adjacent finishes. C. Except for frames installed in metal and wood stud walls or existing walls, grout all other frames solid using mortar type grout only. When temperature conditions necessitate an additive be used in grout to prevent freezing as frames are installed, installer of frames shall coat inside of frames with corrosion inhibiting bituminous material. D. Install door flashing system components as described in this specification, indicated in drawings and as recommended by the flashing manufacturer. E. Doors: Hang with clearances noted in Section 08710, Finish Hardware, unless otherwise indicated or required for rated assemblies. Apply hardware in conformance with SDI -100 and the manufacturer's written instructions. F. Removable Glazing Stops: Install with tamperproof screws, with sealant at penetrations to pressed metal frame. G. Louvers: Install with tamperproof screws as provided by the manufacturer. H. Coordinate installation of hardware including installation of intrusion detection system components and wiring. Intrusion alarm: Coordinate wiring and sensor installation with electrical. 3.03 ADJUST AND CLEAN A. Prime Coat Touch-up: Immediately after erection, sand smooth any rusted or damaged areas of prime coat and apply touch-up of compatible air -drying primer. B. Immediately prior to punch list walk-through, check and re -adjust operating finish hardware items, leaving metal doors and frames undamaged and in complete operating condition. 7