Laserfiche WebLink
FIBERGLASS REINFORCED PANELS <br />Section 09772 <br />15-1207 <br />C. Adhesive: As recommended by the manufacturer. <br />PART 3 - EXECUTION <br />3.01 INSPECTION <br />A. Prior to installation of the work of this Section, carefully inspect and verify that the installed <br />work of all other trades is complete to the point where this installation may properly <br />commence. <br />B. Verify that specified items may be installed in accordance with the approved design. <br />C. In the event of discrepancy, immediately notify the Architect. Do not proceed in discrepant <br />areas until discrepancies have been fully resolved. <br />3.02 INSTALLATION <br />A. Install per manufacturer's installation recommendations using trim, adhesive, fasteners and <br />other means required. Install such that no fasteners are visible in panel field. <br />3.03 CLEANING <br />A. Upon completion of installation, remove manufacturer's labels and marks of identification. <br />Thoroughly wash surfaces and remove foreign material. Leave entire work in neat, orderly, <br />clean and acceptable condition. Replace damaged parts and surfaces, which are not free <br />from imperfections. <br />3.04 PROTECTION <br />A. Protect work and materials of this Section prior to and during installation and protect the <br />installed work and materials of other trades. <br />B. In the event of damage, make all repairs and replacements necessary to the approval of the <br />Architect at no additional cost to the Owner. <br />C. Exposed finishes shall be free from scratches, dents, permanent discolorations and other <br />defects in workmanship or material. <br />END OF SECTION <br />i.11207 lincoln as - cafeteria replacement14.06 projman109772 fiberglass reinforced panels.doc <br />Last Updated., 03/13/06 <br />3 <br />