WORK PLANS - Laserfiche WebLink

Home Browse Search

WALL COVERINGS Section 09950 15-1207 not be accepted. Make vertical seams at least 6 inches from inside and outside corners, and using a straightedge as a guide. Seams shall be straight and truly vertical. Patterns shall be matched and aligned with adjacent material. Install each roll in sequence starting from the highest to the lowest number and each strip in the same sequence as cut from the roll. If pattern is not random, examine the repeat design. Some patterns should be lined up, matched or reversed for best results. If necessary trim salvage deep enough to assure color uniformity. F. If defective material is discovered, stop work and immediately notify Contractor. After the application of three strips, request inspection by the Architect, and if there are variations in color or pattern which are considered to be excessive, the wall covering distributor or manufacturer's representative shall be notified for their inspection before any further wall covering is installed. G. Excessive paste shall be immediately cleaned from surfaces. Scrape material to remove all air pockets and wrinkles and to insure positive contact with wall surfaces. H. Vinyl wall covering is not required behind fixed cabinets or chalkboards and tackboards larger than 4 feet x 4 feet. 3.03 CLEANING A. Upon completion of installation, remove manufacturer's temporary label, marks of identification. Thoroughly wash surfaces and remove foreign material. Leave entire work in neat, orderly, clean and acceptable condition. Replace damaged parts and surfaces which are not free from imperfections. 3.04 PROTECTION A. Protect work and materials of this Section prior to and during installation, and protect the installed work and materials of other trades. B. In the event of damage, make all repairs and replacements necessary to the approval of the Architect at no additional cost to the Owner. C. Exposed finishes shall be free from scratches, dents, permanent discolorations and other defects in workmanship or material. 3.05 EXTRA STOCK A. Extra Material: Furnish in quantity equal to one percent or one bolt whichever is more, of material installed for each type, pattern and color used on the work and taken from the same run as that used for the project. Furnish full width material in one roll increments but not less than one full roll of each type, pattern and color. END OF SECTION i.11207 lincoln es - cafeteria replacementW.06 projman109950 wall coverings.doc Last Updated., June 20, 2014