WORK PLANS - Laserfiche WebLink

Home Browse Search

COMPOSITE TOILET PARTITIONS Section 10170 15-1207 PART 3 - EXECUTION 3.01 INSPECTION A. Prior to installation, carefully inspect and verify that the installed work of other trades is complete to the point where this installation may properly commence. B. Verify that toilet partitions may be installed in complete accordance with the original design. Verify solid blocking has been provided in walls and ceilings at all partition locations. Do not install if blocking is missing. C. In the event of discrepancy, immediately notify the Architect. Do not proceed in discrepant areas until discrepancies have been fully resolved. 3.02 INSTALLATION A. Install all toilet partitions and screens where indicated on the Drawings and reviewed Shop Drawings, anchoring all components firmly in place into solid blocking for long life under hard use and in compliance with manufacturer's recommendations. B. General: Install partitions and screens rigid, straight, plumb and level. Maximum variation from plumb is 1/8 inch. Provide clearances of not more than 3/8 inch between pilasters and panels, and not more than 1/2 inch between panels and walls and not more than 3/16 inch between vertical edge of doors and pilasters. Secure panels to walls with full length, continuous wall brackets using stainless steel fasteners spaced maximum 12 inches O/C. Attach panels and pilasters to continuous brackets with theft resistant sex bolts. Shoes anchored to floor with 1-1/2 inch, #14 stainless steel screws and metal anchors. Pilaster secured within shoe with theft resistant sex bolt. C. Secure pilasters to supporting floor and ceiling with specified anchorage devices. Level, plumb, and tighten. Adjust tops of doors parallel with floor and ceiling. D. Hardware adjustment: Adjust and lubricate hardware for proper operation after installation. 1. Set hinges on in -swing doors to hold doors open approximately 30 degrees from closed position when unlatched. 2. Set hinges on out -swing doors to return to fully closed position. 3.03 ADJUSTING AND CLEANING A. Upon completion, and as a condition of acceptance, visually inspect the entire work of this Section and adjust all components for proper operation and straight alignment. All surfaces shall be free of imperfections, scratch marks, blemishes or color variations. B. Upon completion, thoroughly wash surfaces, remove foreign material, polish surfaces. Leave entire work in neat, orderly, clean, acceptable condition as approved. Replace damaged parts, surfaces which are not free from imperfections. Field touch-up of scratches or damaged finish will not be permitted. Replace damaged or scratched materials with new materials.