WORK PLANS - Laserfiche WebLink

Home Browse Search

METAL SHELVING Section 10670 15-1207 Gauge with front and rear "Box W" formation. The front and rear "Box W" formation shall not be less than 1-11/64" x 27/32" x 1-1/8" with 9/16" return flange spot welded to the bottom portion of the shelf. The 27/32" portion of the "Box W" shall have a 10 -degree bend in the center for additional rigidity. The front and rear flanges on the shelf shall be punched to accept bin fronts, label holders and other accessories. Ends are to be flanged not less than 1-11/64" with a 90 -degree return flange of not less than 5/8". All corners shall be lapped and welded. All shelves shall be punched on 3" centers for divider attachments. Shelves shall also be punched at 4 -corners for bolting to the up -rights. The front and rear flanges of the shelf are to be embossed with the words "18GA." 4. Lateral cross braces shall be 1" x 12 -gauge band formed and punched at each end to bolt to upright T. One pair of lateral cross braces shall be provided for every three shelving sections with shelf spacing at less than 30". Shelving sections with 30" or greater shelf spacing shall be provided with two pair of lateral cross braces with every three shelving sections. 5. Swinging doors shall be 20 -gauge steel with one full -height 24 -gauge pan reinforcement per door. Each pair of double swinging doors shall have three-point latching with one built-in lock. One pair of double swinging doors shall cover one full section of shelving. 6. Each shelving unit shall be a minimum of 36"wide x 84" tall x 18"deep or as dimensioned in plans at various locations. 7. Braced end units and braced or un -braced adder units shall be fabricated per manufacturer's standard for conformance to applicable seismic requirements. 8. Free-standing units shall be braced overhead and connected to building structure by a steel angle or cold rolled steel shape system designed by the manufacturer. 9. Colors shall be as selected by the Architect from full range of manufacturer's available colors. 2.02 MISCELLANEOUS ITEMS A. Provide all miscellaneous fasteners, brackets, supports, braces, connectors and accessory items as indicated on the Drawings or as required by the manufacturer for a complete and proper installation of the materials, products or systems specified in this Section. PART 3 - EXECUTION 3.01 INSPECTION A. Prior to installation of the work of this Section, carefully inspect and verify that the installed work of all other trades is complete to the point where this installation may properly commence, including blocking. B. Verify that specified items may be installed in accordance with the approved design. C. In the event of discrepancy, immediately notify Architect. Do not proceed in discrepant areas until discrepancies have been fully resolved. 3.02 PROTECTION A. Protect work and materials of this Section and other Sections prior to and during installation, 3