WORK PLANS - Laserfiche WebLink

Home Browse Search

ATHLETIC EQUIPMENT Section 11480 15-1207 PART 2 - PRODUCTS 2.01 EQUIPMENT A. General: The following athletic equipment systems and components were selected to establish a level of quality. Other products shown to be equal in materials, workmanship and durability and meeting the physical conditions of the job will be considered by the Architect. All systems and components listed are by Porter Athletic Equipment Co. of Broadview, IL., unless otherwise noted. B. Basketball Backstops - Forward Fold Unit: Porter No. 917 or 917-W if applicable, "center strut" Ceiling Suspended, Forward -Fold, Rear Braced. 1. All metal parts shall be powder coated. Architect may choose from 9 -standard color options. 2. Operation: Electric with Porter No. 706, 1/2 H.P electric winch for attachment pivot points up to 28 feet above the floor and Porter No. 707, % H.P electric winch for higher than 28 -feet above the floor attachment of pivot points. 3. Backboard: Porter No. 208, Rectangular Glass Backboard with No. 326 Pro -Pad Rectangular Backboard Padding Kit (bolt -on). 4. Goal: Porter #245-500 Ultra Flex goals with a release mechanism that can be adjusted without removing the housing cover for high schools. For all other schools provide Porter #252-500 Torq-Flex Goal or Porter #245-500. C. Equipment Controller: Provide Porter No. 02555-000 POWER -TOUCH 2.5, Simultaneous Operation Gym Control Center. 1. Wall Touch Pad system to have capacity to raise or lower backstops in any programmed option and up to 4 backstops at the same time. Include one dual powered relay panel allowing connection for up to 8 moveable items. Touch Pad shall incorporate a four -digit programmable security code to prevent usage by unauthorized personnel. Touch Pad security code to be easily re -programmed to prevent unauthorized usage. Touch Pad to automatically revert to secured mode if no button is pushed within a thirty second time period. Touch Pad shall be flush mounted in a standard four inch square electrical box, with a 12 Volt control circuit running to the relay panel. Touch Pad to have a tri -color LED for positive user feedback. 2. Control system must have capability for in -field re -programming by owner, should owner want to change operation options or add equipment for operation. Pre-programmed chip type programming for control centers are acceptable only if supplier provides new programming chips at no cost to the owner for the life of the Touch Pad control use. 3. To assist in identifying the equipment number assignment for single or multiple operation provide Porter No. 92500-000 Legend, 11"x17" in size. Legend to be positioned above the touch pad for a visual reference of the equipment layout. 4. Wiring of equipment to the relay panel and control wire from relay panel to the Touch Pad to be by Electrical Contractor. 5. Equipment Controller to operate the following equipment: a. Motorized Basketball Backstops. D. Indoor Volleyball Standard Sleeves: Provide No. 870 sleeves, 5" diameter cover for 3-1/2" OD posts for installation in all fixed type floors. Provide No. 872 sleeves, 8" diameter cover for 3-1/2" OD posts for installation in all floating wood floors. Provide cover options in brass C