WORK PLANS - Laserfiche WebLink

Home Browse Search

ATHLETIC EQUIPMENT Section 11480 15-1207 or silver color. Volleyball standards are a part of this contract. Provide 3 -complete sets of sleeves and standards. E. Indoor Volleyball System: 1. Standards: Porter No. 1971-000 "Powr-Rib II" Competition, Sleeve -Type, 3-1/2 inch aluminum volleyball standards. Provide center standard(s) arrangement if applicable. 2. Net(s): Porter No. 02295-630. 3. Upright Protective Pads (pair): Porter No. 717-000 Standard Volleyball Upright Pads. Provide center standard pads if applicable. F. Wall Pads: Porter No. 00560-Oxx "HiNRG Safpad" Wall Padding with 1" Nailing Margins. 2 - inch thick rebonded foam cemented to 7/16 -inch thick OSB backing board covered with 14 ounce non -tear vinyl laminated material which shall have a rip resist and quality utilizing industrial polyester filament yarns. Assembly shall be mildew and rot resistant, and fortified with an infection combating fungicide. Cover material shall be designated as flame retardant in accordance with NFPA 701, and State of California (Registered Fabric No. F-140). The fabric shall be placed over the filler, folded and stapled securely to the back of the backing board. Provide a 1 -inch wide fabric covered nailing margin at the top and bottom for securing panels to the wall. Provide a minimum of 14 -colors for architect selection. G. Indoor Scoreboard: Daktronics No. 1313-2101-13, 4'x8' with PanaView Digit technology. Include one pair of No. BB -2114-13 Shot clocks. Include soft carrying case and signal cable as required. Provide in quantity as shown on plans. Provide 2 -control consoles. [EDIT for radio control if desired by District.] 2.02 MISCELLANEOUS ITEMS A. Provide all miscellaneous fasteners, brackets, supports, operators, controls, connectors, and accessory items as indicated on the Drawings or as required by the product manufacturer for a complete and proper installation of the materials, products or systems specified in this Section. PART 3 - EXECUTION 3.01 INSPECTION A. Prior to installation of the work of this Section, carefully inspect and verify that the installed work of all other trades is complete to the point where this installation may properly commence. B. Verify that specified items may be installed in accordance with the approved design. C. In the event of discrepancy, immediately notify Architect. Do not proceed in discrepant areas until discrepancies have been fully resolved. 3.02 INSTALLATION A. Install athletic equipment in strict compliance with original design, manufacturer's recommendations and reviewed Shop Drawings. 4