SR0081937_OWTS - Laserfiche WebLink

Home Browse Search

'MST/ILL/A' VON Water Supply Valve: The provided feed water valve adapter is de- signed to adapt to 1/2"-14 NPS or 3/8" compression angle stop adapt- al11111111==21 ers. If it is out of code compliance or fails to provide a proper installation connection, you will need to source an alternate valve with connectors from a plumbing 1/2" supplier. Install to the cold water supply line only. Faucet: The faucet should be positioned accounting for function and appearance. Take great care prior to installing the faucet as a permanent hole may need to be drilled in 3/ " 8 the sink. Use a pre-drilled hole if available. If a hole must be drilled, carefully Compression choose a position with an adequate accessible flat area that allows for proper clearance. Most sink types require a special drill bit that will be specific to the material being drilled. The hole size required will vary based on the style and type of faucet. To help protect NPS 1 11111040..L." drilling site use masking tape to cover and surround the area. Use safety glasses and adequate protection to prevent the inhalation of irritating or dangerous residue. Install the faucet 110 firmly, but do not over-tighten. Install the John Guest faucet adapter on the shaft of the faucet and tighten no more than 1/4 turn past hand tight. Conform to local codes by installing an air gap faucet or other approved air gap device as required. Remove white paper to expose Drain Clamp: The drain configuration will vary based on sticky tape, apply the type of faucet. A non-air gap faucet will have a 1/4" gasket as shown. drain line connection. An air gap style faucet will require a 3/8" drain line connection. The drain operates under low pressure or mere gravity. It is critical to install the drain line in an efficient manner that avoids unnecessary length, bends and loops. If the drain connection device included with the system is not code approved in the installation area, use an alternate, code approved drain connection method. Attach the drain clamp to a vertical section of the drainpipe about 6" above the trap and clear of any garbage disposal as debris can restrict the drain flow and pre- vent proper system operation. Consider replacing any damaged or corroded drain pipes prior to completing system installation. The connection of the drain clamp should face the system faucet. Taking care not to damage the drain pipe, drill a 'A" to "hole and file clean any Assemble the saddle clamp as shown, be sure to align the holes! Drill a 3/8" hole as shown. Never install the drain saddle on the house side of the P-Trap. rough edges. Use a drill stop collar to prevent damage to the opposite wall of the drain pipe. Line up the hole in the drain clamp with the hole in the drain pipe, making sure the drain clamp gasket is in place. Do not over-tighten. Shorten the provided drain tubing to allow for a relatively straight line connection. Take great care NOT to trim the drain line tubing on the end where the drain flow restrictor is installed. This will typically be identified with a small sticker that reads "Flow Capillary Inside." An Storage Tank: Wrap the •14" MNPT storage tank connection 'Iwo point with an appropriate amount of Teflon tape. Hand tighten (do not over-tighten) the provided tank ball valve onto the stainless nipple. Using a high quality, accurate, low range air pressure gauge, adjust the empty storage tank air pres- sure to 5-7 psi. Test for leaks.