Laserfiche WebLink
INFORMATION SHEET <br />SAN JOAQUIN COUNTY SERVICE AREA 31 <br />AMADOR CORPORATION <br />CALIFORNIA STOP WASTEWATER FACILITY <br />SAN JOAQUIN COUNTY <br />The San Joaquin County Service Area 31 has been formed to provide wastewater <br />treatment and disposal services to the California STOP development, on the east <br />side of the intersection of Interstate 5 and State Highway 12 in San Joaquin <br />County. The property on which the treatment plant will be constructed is owned <br />by Amador Corporation, the developer of the property. <br />Although the location of the development is near the White Slough Water Pollution <br />Control Facility, sewerage service could not be provided. Therefore, a package <br />plant was proposed to treat the estimated 0.25 MGD flows, and to discharge <br />effluent to Highline Canal, which is used directly to recharge wetlands and <br />irrigate agricultural land. The City of Lodi's plant (recently expanded to treat <br />up to 8.5 MGD) discharges at approximately the same location where Highline Canal <br />enters Dredger Cut. Due to tidal action, Lodi effluent may make up a significant <br />percentage of the water in Highline Canal. <br />In order to minimize any water quality impacts from its wastewater discharge, the <br />Discharger proposes to build treatment facilities to meet 10 mg/l each for BOD <br />and suspended solids, and 3 mg/l for ammonia (as N). <br />Due to its location at the upstream end of Highline Canal, there was no <br />appropriate upstream receiving water sampling location. Therefore, sampling has <br />been limited to effluent and a downstream sampling location. The City of Lodi <br />currently samples water further downstream in Highline Canal, as well as <br />locations in Dredger Cut, White Slough, and Bishop Cut. <br />Water Quality Objectives, adopted pursuant to the Enclosed Bays and Estuaries <br />Plan and the Inland Surface Waters Plan, are applicable to the discharge. <br />Therefore, once the facility is constructed, effluent samples will be analyzed <br />for compliance with appropriate objectives. If the effluent is not in <br />compliance, the Board may reopen the permit to require additional actions. <br />Sludge is proposed to be dried on sand beds and hauled to a landfill for <br />disposal. The Discharger is required to submit a sludge disposal plan within 60 <br />days of initiating the discharge. <br />Finally, the Discharger is required to conduct an effluent toxicity monitoring <br />program to estimate if the discharge produces instream chronic toxicity. The <br />Discharger is required to investigate and correct any toxicity problems which <br />occur. <br />PHL:pl <br />