SR0084253_OWTS - Laserfiche WebLink

Home Browse Search

No -traffic Area Installation Procedure Checklist cont. ❑ Step 8 continued: Alarm Panel shall be: ✓ in a well ventilated area as dry and protected from elements as possible ✓ in as close of proximity to FujiMAC air blower as possible ✓ wired by licensed electrician ✓ in a location that allows unencumbered access for inspection and maintenance activity ❑ Step 9: For cold climate installations, please install insulated risers and covers and cover upper half of treatment unit with min. R-8 value insulating material (i.e. foam board) ❑ Step 10: Float switch electrical cord should exit riser wall through a male adaptor (caulked watertight to prevent septic gas leakage) or watertight fitting. An interior connection to direct burial cable is also an acceptable option. ❑ Step 11: In nearly all cases, the Fuji Clean system will vent properly through the building's septic influent line. In cases where there is an influent pump, or in severe downdraft locations, a separate vent should be considered. If you do choose to install a vent, be sure that the vent slopes toward the tank so that any moisture accumulation drips back down toward the tank. ❑ Step 12: During final landscaping, seeding etc., be sure to pitch final grade away from covers to sweep surface water away from treatment tank. ❑ Step 13: Complete Warranty Activation Card. ❑ Step 14: Finalize Controller Wiring. Please have licensed electrician refer to wiring diagram (in Installer Manual and enclosed separately in alarm/control panel). Upgraded Fuji Clean USA controllers are available if telecommunications, elapsed time meter, data logging or other functions are required. Please contact Fuji Clean USA for details. ❑ Step 15: Follow start-up procedure detailed in Installation Manual: ❑ 1. Outside Environment Check ❑ 2. Blower Box Check ❑ 3. Blower Operation and Blower Alarm Check ❑ 4. Water Level is at Low Water Level ❑ 5. High Water Float Switch Check ❑ 6. Set Recirculation Control Valve. (gray) ❑ 7. Check Recirculation Flow Rate ❑ 8. Check/Set Aeration Balance Control Valve (blue) ❑ 9. Check/Set Effluent Airlift Valve (white) ❑ 10. Check Effluent Airlift Pipe ❑ 11. Add Disinfectant Tablets to Chlorinator (if appropriate) ❑ 12. Check Alarm/Control Panel and Air blower ❑ 13. Final Site Preparation ❑ 14. Owner Communication - Service Provider and Warranty Delivery Fuji Clean USA • 41-2 Greenwood Road • Brunswick Maine 04011 • Tel: 207-406-2927 • Fax: 207-406-2929 • www.fujicleanusa.com 43