SR0084253_OWTS - Laserfiche WebLink

Home Browse Search

• Fu)iClean TM LLC Toward Clean Water... No-traffic Area Installation Procedure Checklist Note: Please consult Installation Manual for detailed instructions. Unloading Instructions: Upon delivery, inspect Fuji Clean tank, both outside and inside for possible damage incurred during transport. If you find damage, or have a question, please contact your distributor immediately. ❑ Step 1: Prepare excavation to be at least 1 to 2 feet larger than the Fuji Clean tank dimensions. Note: Riser height should not exceed 24". ❑ Step 2: Prepare 4"- 6" bed of stone (1/8") sand, or poured concrete level to within 1/8". ❑ Step 3: Use 4 -point lifting lugs. Carefully lower and set tank. Level to within 1/8 -inch per 2 -ft. ❑ Step 4: If any part of the tank is below the estimated seasonal high water table, adequate tank uplift restraint measures should be taken. Please refer to Installation Manual for recommended options. ❑ Step 5: Re -check that tank is level to 1/8 -inch per 2 -ft., (fore and aft as well as side to side) and then fill tank with fresh water to the low water line (marked inside tank). Start 24-hour water tightness test. (Please contact your distributor or Fuji Clean USA if water level has dropped after 24 hours). ❑ Step 6: Backfill about 3/ way up tank in layered, compacted 6" lifts using peastone or equivalent material that form -fits into tank corrugations. Install inlet/outlet lines using 5x4 reducing bushing if necessary. ❑ Step 7: Using supplied adaptors and fittings, attach air pipe fitting to tank and connect to 3/" or 1" conduit in prepared trench (min. 6" deep) to location of air blower. For CE14, 21, CEN10 and 14, locate blower within 33' for 3/" or 1" air line or 100' for 1" air line. For CE30 and CEN21 use 1" air line. Connect with no more than 5 elbows on each models. ❑ Step 8: Locating and Installing Blower/ Control Panel. Air Blower shall be: ✓ in as close proximity to control panel as possible ✓ on a solid (e.g. concrete) pad to minimize vibrations ✓ in a location above water level ✓ away from grease exhaust fans. ✓ away from bedroom windows and other locations where operational sounds (although minimal) may be a nuisance ✓ In a location that allows unencumbered access for inspection and maintenance activity ✓with proper electrical grounding -'with wiring and electrical connections made by a licensed electrician. ✓with no objects on top of electrical cord. ✓ in a well -ventilated space out of direct sunlight and protected from elements such as direct rain or snowfall. Fuji Clean USA • 41-2 Greenwood Road • Brunswick Maine 04011 • Tel: 207-406-2927 • Fax: 207-406-2929 • www.fujicleanusa.com 42