INSTALL_2001 - Laserfiche WebLink

Home Browse Search

Flexible Entry Boot environ 1.4 Chemical Compatibility Part No. Size Application All seals are made of specially formulated Buna-N Rubber compound FEB-3050 1/2" Standard use which has been independently tested to insure its compatibility with a FEB-3075 (4.25'O.D.) 3/4" Standard use wide assortment of chemicals measuring its swell features under FEB-3075A(3"O.D.) 3/4" Congested areas exposure as well as degradation characteristics.These tests included FEB-3100 1" Standard use measuring the material's retention of properties as well as the physical characteristics of the seal after exposure. 2.2 Pipe Entries WARNING: Keep all fiberglass cleaning solvents away from boots.These types of solvents could cause severe damage. There are eight sizes of pipe entry boots to accommodate various types of piping. These entry boots may be 1-•-.?� 1.5 Angled Entries installed in either the sidewall of a f ' dispenser sump or in the bottom of a Flexible entry boots are flexible enough dispenser pan. to permit angled pipe or conduit entries (on two axis) into the sidewall of a containment chamber. This seal is also capable of multi-directional pipe alignment either up and down or side to side. This vital feature also allows Part No. Size Application accommodation of pipe entry holes FEB-3150 1-1/2" Flex and Rigid Pipe which are installed slightly off exact FEB-5150 1-1/2" Flex and Rigid Pipe alignment in the chamber wall. This FEB-6150 1-1/2" Flex and Rigid Pipe movement will prevent the chamber wall from putting undue stress FEB-6200 2" Flex and Rigid Pipe on the pipe coupling/fitting joint and the entry boot as well. For flexible FEB-6300 3" Flex and Rigid Pipe piping applications within dispenser sumps, the stresses on pipe FEB 7390 3.9" Rigid Pipe&Containment&Flex fittings below the product dispenser's inlets are minimized by the boot's alignment flexibility. FEB-7400 4" Rigid Pipe FEB-8600 6" Rigid Pipe Pipe and conduit entering the containment chambers may not be perpendicular with the wall of the chamber. Angled entries are generally a result of directional plumbing restrictions on the inside of 2,3 Duct Entry Boots the containment chamber due to space limitations.All flexible entry boots permit angled entries up to a 15 degree angle off the center line There are two sizes of duct entry boots in any direction without breaking a seal or putting undue stress on the to accommodate both flexible and rigid pipe conduit or entry seal. ducting. Ducting pipe is typically used when removability of the flexible pipe is desired after installation. These entry WARNING: Angles greater than 15 degrees off center could boots may be installed only in the i possibly cause the rubber boot to tear due to prolonged sidewall of a dispenser sump. These stress. boots typically require the use of split reducer donuts to seal the boot when reducing down from ducting to the 2. ENTRY BOOT APPLICATIONS primary piping. There are a number of different sizes Part No. Size Application and types of flexible entry boots k= designed to meet all GeoFlex° system FEB-6350 3" Standard use applications. The following types of FEB 7450 4" Standard use flexible entry boots and seals available are described as follows: 3. INSTALLATION INSTRUCTIONS For proper and warranted installation of 2.1 Conduit Entries flexible entry boots, these instructions There are four sizes of conduit entry must be followed.Prior to installing the { boots made to accommodate 1/2", rubber entry boots,make sure the exact 3/4",1", conduit.These entry boots may location has been properly calculated. be installed in either the sidewall of a sump access boots may be used to dispenser sump or in the bottom of a f permanently seal any miscalculations. dispenser pan. 2