INSTALL_2001 - Laserfiche WebLink

Home Browse Search

Flexible Entry Boot mamial environ 3.1 Bolt Holes 3.5 Clamp Fastening Locate the center entry point in the flat ' Insert the appropriate sized pipe or wall section of the sump base and _ .,_• conduit into the flexible boot from drill a 5/16" hole. Install the entry boot •'' , outside of the sump. After the pipe or template to the sump base wall using a - conduit has been positioned, install the 1/4" bolt and nut. Drill out the band clamp around the boot and tighten appropriate bolt hole circle for the size to 30 in.lbs. boot to be installed using the same 5/16" drill bit. After drilling, remove the WARNING: Do not over tighten the template from the sump base wall. band clamp beyond the maximum torque of 30 inch pounds or it is For proper installation, the appropriate size fabrication template possible to damage the rubber boot. should be used for accurate hole drilling. 3.2 Boot Openings 4.SUMP ACCESS BOOTS After the bolt hole circle has been drilled An optional "plug" style boot is ¢� drill the entry boot opening by using the e,, available.This boot was designed to seal appropriate size hole saw. After the holes that are purposely drilled in the opening is drilled, clean any rough side of a dispenser sump for easier edges with a deburring tool or razor access to the sump's plumbing,or to seal knife. any mistakenly drilled holes.See section WARNING: The recommended hole3_2 for proper hole saw size(Part#SAB- . saw size must always be used for 7400). proper installation of the flexible entry boot. Failure to use the required hole saw could damage the rubber boot after installation or prevent the boot from sealing properly. 5. FLEXIBLE ENTRY BOOT INSTALLER TOOLS In order for proper installation of the Hole Saw Flexible Entry Boots flexible entry boot,the correct size bolt 1-3/4" FEB-3075-A(3"O.D.) holes and boot openings must be drilled. 2-3/8" FEB 3050,3150,3075(4.25"O.D.),3100 The following installer tools are f�7�►,� available: 3" FEB 5150 4-1/4" FEB-6150, FEB-6200 � a 4-1/4" FEB-6300, FEB/GDB-6350 .:... 5-1/2" FEB-7390,7400 5-1/2" SAB-7400, GDB-7450 Saber Saw FEB-8600 5.1 Entry Boot Templates These predrilled metal templates have all of the bolt hole patterns for each size 3.3 Installing Rubber Boot flexible entry boot. Refer to section 3.1 Install the rubber boot from outside the of this manual for usage of the entry sump by inserting the studs through the boot template. bolt holes.From the inside of the sump install the compression ring over the studs and install nuts by hand. n 5.2 Hole Saws Hole Saws are available in a variety of 3.4 Boot Fastening sizes to accommodate different size Using a 7/16"nut driver,tighten all of the flexible entry boots. Refer to the chart nuts evenly and firmly. To prevent under section 3.2 for the appropriate hole deforming the boots do not over tighten saw for the type of flexible entry boot +a4, nuts.If a torque wrench is used,the setting being used. should be 60 in.lbs. ,- 3