SR0085076_OWTS - Laserfiche WebLink

Home Browse Search

14 Paul W. Donoho, R.E.H.S. #6227 (530) 701-9972 AdvanTex@ O&M COMMERCIAL , Inspection ' • • - • 7.Panel operation:Verify that the panel is powered up. 4.Splice box.Inspect + On TCOM and VCDM panels,an LED will light up indicating the the splice box for board is operational.If the blinking light does not tum on,refer correct wiring and to the wiring diagram and verify the connections on the control the use of waterproof circuit were properly terminated. splice nuts.If there is water in the splice box, use a baster or sponge to remove the water. WARNING:Failure to use waterproof wire nuts can cause intermittent or permanent float failure, a: FC • 5.Effluent filter and float:Verify the effluent fitter cartridge and float assembly are easy to remove for service and maintenance. The ability to easily remove these components is essential and �'seo.roe �d s•sa• depends upon careful installation in accordance with the instructions Blinking LED- provided in Appendix B.Set components on a plastic tarp or plastic sheeting when they are out of the tank, • On MVP,Simplex,and Duplex panels,tum on the control circuit, a.Detach the float assembly from the housing,remove it from the then toggle the pump"AUTO-OFF-MAN"switch to"MAN."The tank,and lay it aside.Verify there is enough slack in the cord for motor contactor will visibly and audibly engage at this point.If easy removal. the motor contactor does not engage and there are no alarm conditions,refer to the wiring diagram and verify the connections b.Pull the effluent filter cartridge out of the housing,and remove on the control circuit were properly terminated. it from the tank_There Should be ample clearance to allow NOTE,ForVCOM-equipped systems,place VCDM in test mode unhindered removal of the cartridge from the housing and tank. at this point. c.Slide the filter housing out of the slide rail and remove the housing Inspection Points—Tanks and Basins from the tank.(Slide rail models only.) d.Raise the high-level alarm float to simulate a high-level condition. Not all tanks and basins have associated components as described below. Verify that the high-level signal is on by the audible alarm or the Check the system plans to Idenfrfy if there are associated components— high-level alarm input LED on the circuit board in the panel, such as splice boxes,floats,filters,or pump vaults—on each section of the system as you start it up. NOTE:The audible alarm is delayed for 2 hours in ICOM comrol 1.Tank:Confirm with the installer that all tanks have passed panels. watertightness testing.Verify the inlet and outlet of the tank and riser e.When the floats and filter cartridge are out of the tank,verily,the are properly installed. handles are long enough for easy access.If they are not,adjust 2.Basle:Verily the inlet and outlet of the basin are properly installed them to the necessary length, and the effluent flows through in the correct direction. f. Reinstall the cartridge into the effluent filter housing and install the 3.Riser:Inspect the riser attachment and rubber grommets for a float assembly. watertight seal. AIM-OM-ATX-9,Nev.�2,7,08!75 �•� Copyright OrCrlco Systems®,fn¢Property of orenco Sy5t0m5®,Inc.Do not reproduce or tllsirihute without written authonzatlat from ereoao:'8n0-348-9843