Laserfiche WebLink
Health and Safety Plan <br />June 16, 2021 <br />Page 2 <br /> <br /> <br />2.1.1 Ambient Air Monitoring/Respirator Requirements <br />Benzene, a constituent of gasoline, will be used as an indicator parameter for ambient air monitoring. <br />Because benzene is a suspected carcinogen and, therefore, highly regulated, it will be useful as a <br />conservative indicator parameter. The following discussion assumes that exposure to benzene is a <br />possibility; thus, a safety measure for other potential air-borne contaminants is achieved. <br /> <br />a. Breathing zone vapor at detectable concentrations at the drilling area greater than 1.0 parts per <br />million (ppm) for five minutes, as detected by PID, requires site personnel to use a respirator <br />with organic vapor cartridges while working in the exclusion zone. As a reference, the OSHA- <br />PEL for benzene is 1.0 ppm. <br /> <br />b. Breathing zone vapor at detectable concentrations requires site manager to monitor the site <br />perimeter (concentrating in the down wind direction). <br /> <br />c. Breathing zone vapor concentrations that reach or exceed 10 ppm during drilling activities at <br />the drilling area, as detected by the PID, requires site personnel to use a respirator with organic <br />vapor cartridges while working in the exclusion zone. <br /> <br />d. Breathing zone vapor concentrations that reach or exceed 50 ppm at the drilling area, as <br />detected by the PID, requires site activities to be stopped until concentrations decrease. Site <br />manager should continuously monitor site perimeter. <br /> <br />e. If breathing zone vapor concentrations are detected at the site perimeter, the site manager shall <br />monitor the perimeter at 30 minute intervals. <br /> <br />f. If the vapor concentrations continue to reach or exceed a value of 10 ppm at the site perimeter <br />for 15 minutes, drilling activities shall be stopped. Appropriate regulatory agencies should be <br />contacted (see contact sheet). Site manager shall continue to monitor conditions until levels are <br />reduced to background conditions. <br /> <br />2.2 COVID-19 <br />Due to the rapidly changing nature of best practices for enhanced protect from infectious transmission of <br />COVID-19, the recommendations provided are guidelines and should be revised as-needed at the tailgate <br />safety meeting prior to start of field activities. Generally, the following shall be followed: <br /> <br /> Maintain a social distance whenever possible during the work. <br /> Monitor fellow workers for outward signs of symptoms of COVID-19. Workers that are sick or <br />show other visible signs shall be sent home. <br /> Use gloves when passing equipment between workers. <br /> Wear cloth or disposable face masks when required to regularly work inside the social distance. <br /> <br />Follow recent guidelines provided by OSHA or other applicable regulatory body for similar work in <br />addition to the above guidelines. <br /> <br />2.3 SKIN/CLOTHES PROTECTION <br />Steel-toed boots and hard hats will be worn during all field activities. <br />