Laserfiche WebLink
" CONY Retrofit Plate " Kit Contents <br /> Contents . <br /> ( 1 ) Pre - abraded Tank- spec FRP panel <br /> ( 1 ) Bravo Adhesive- Epoxy- Retrofit- Kit <br /> ( 1 ) Stir Stick [NOT SHOWN] <br /> ( 1 ) 1 " chip ( paint) brush <br /> ( 1 ) Emery sanding strip [NOT SHOWN] <br /> ( 1 ) Large pair nitrile gloves <br /> ( 1 ) NOTICE label <br /> ( 1 ) MSDS package [NOT SHOWN] <br /> FRP Plate material : <br /> UL Listed fiberglass ( UL1316 matched ) <br /> ( Material MSDS included in package ) <br /> The panel is technically the same as <br /> a piece of our CUL/ US Listed SingleWall <br /> sump wall and is nominally 1 /4 " thick . <br /> 1NOTICE <br /> ' <br /> • 0 <br /> Image of the <br /> NOTICE label THE FIBERGLASS RETROFIT PLATE ( S ) BONDED WITH EPDXYTO THIS <br /> CONV - 62000 ( UDSCCS ) CONVERSION FRAME IS A STATE -AUTHORIZED <br /> MODIFICATION PROVIDED BYWAY OF THE PRODUCT INSTALLATION <br /> MANUAL AND MANUFACTURER CONTROL . REFER TO THIS PRODUCTS <br /> STATE APPROVAL LETTER AVAILABLE AT WWW. S13RAV0 . 00M / CONV <br /> STANDARD KIT SIZES <br /> Based on our evaluation of the specific application and site conditions , we have determined two <br /> standard kit sizes will apply to a majority of conduit interference issues . They are : <br /> CONV- Retrofit- Plate -6x18 6 " x18 " panel intended for the short ends of the conversion frame <br /> CONY- Retrofit- Plate -4x25 4 " x25 " panel Intended for the long sides of the conversion frame <br /> NOTE : Due to the custom nature of each custom conversion frame and application , the fiberglass <br /> panels in the CO NV- Retrofit- P late kit may require different dimensions than the sizes listed above . <br /> In this case the dimensions of the panel will change on the end of the part number. <br /> 2 ii -CONV- Retrofit- Plate- 1213 - 9/24/2012 <br />