Laserfiche WebLink
0 AnthonyModel 401 & 403 Pass-Thru <br /> Service and Installation Instructions <br /> •�. 99-21972-S001 Rev. A <br /> Remove Existing Lighting System <br /> 1. Remove the following items.- <br /> a. <br /> tems:a. Lens <br /> b. Fluorescent lamps <br /> c. Lamp holder <br /> d. Mounting clips <br /> e. Ballasts from existing lighting system <br /> NOTE: Refer to case manufacturer's instructions for any questions <br /> on removing the fluorescent system and ballast. <br /> 2. Seal any open holes on Mullion using neutral cure silicone sealant (not <br /> provided). <br /> 3. Make sure you save the two #8 tapping screws used to hold the ballast in <br /> place. <br /> Mounting the LED Power Supplies <br /> 1. Install the LED power supply in the same location where the ballast was fitted <br /> or in the general location for ease of wire connection. <br /> 2. Mount the LED power supply using two #8 tapping screws saved when the <br /> ballast was removed <br /> NOTE: Installer may have to drill two holes in raceway to <br /> accommodate LED power supply if the door is not an Anthony <br /> model. <br /> NOTE: The LED power supply case is grounded. Attach the LED <br /> power supply to a ground point in the refrigerated directly with <br /> a screw. <br /> 3. Reinstall raceway cover(s). <br /> Locate, Drill and Mount the LED Fixture to the Mullion <br /> Prior to drilling, make sure there are no existing components inside the mullion in the <br /> areas marked off for the designated holes. <br /> NOTE: Drilling is not required for an Anthony model frame. Pre- <br /> existing holes are used. <br /> 1. Using a ruler, measure the total width of the mullion at (A) and (B), and mark <br /> a vertical line half the total width near the top and bottom of the mullion, as <br /> shown in the following illustration. <br />