Laserfiche WebLink
Model 401 & 403 Pass.•Thru <br /> ® Anthony Service and Installation Instructions <br /> •�,COWAW 99-21972-S001 Rev. A <br /> 7. Check frame for square as shown. Shim as necessary. Ensure that shims are <br /> placed as close to installation holes as possible. When shimming is necessary, <br /> shim top to bottom and/or left end of frame and right end of frame to maintain <br /> square of frame in opening. <br /> 8. From the inside of case, caulk all four sides of frame between frame and case <br /> opening, as shown above. <br /> 9. Starting with frame sill, install mounting screws and tighten. First do sides, then <br /> top. (Do not over-tighten top screws as this will bow frame.) <br /> 10. From inside the case, re-check caulking and re-caulk as necessary. <br /> 11. For joining frame sections without flanges on center section, or one end of left <br /> end and one of right end of frame, align top and bottom with end sections and <br /> join together with sex bolts provided. <br /> Model 401 Door & Hold Open Installation <br /> NOTE: Remove HoldOpen Bolt from Frame <br /> and Leave Hold Open Arm Attached to Door <br /> E-Clip for Hold Open <br /> Arm Retention on Door Q+ <br /> �— Left Opening STEP 2 <br /> Attach this End to <br /> 1/4-20 BoIVPivot Stud the Frame <br /> on Door STEP 1 <br /> Attach this End to <br /> the Door 1/4-20 Bolt w/5/8" <br /> Hex Head on Frame <br /> Right Opening <br /> 1. Hold-Open arm attachment is at the top of the door. <br /> 2. Align the door with the torque rod and insert it into the Torquemaster socket at <br /> the base of the door. <br /> Y <br />