COMPLIANCE INFO - Laserfiche WebLink

Home Browse Search

Removing the Paper Roll EQUIPMENT ALERT Be sure to pull the paper out of the top of the printer (paper cutter o side). Pulling the paper out of the back of the printer will damage the printer mechanism. Before removing the paper roll, advance the paper about 2.5 cm (1 in.) beyond the paper cutter by pressing down and holding the switch to the ON / FEED po- sition. Lift the paper roll away from the printer housing, and with a scissors, cut the paper roll feeding to the printer. Try to make the cut as straight as possible to facili.afe the next reloading of the paper. Now, pull the remaining paper through the printer mechanism. Power Up Message When the printer is first turned on, it prints the word READY to assure the oper- ator that its built in microprocessor is working properly. When turning the printer OFF, wait at least 3 seconds before turning the printer back on. Printer Tape Description The pri-iter will print the following information for each program cycle: Set Tenperature Set Time Run Number Date: a blank line is printed so that the date can be recorded on the printer tape. The pri-iter will print the chamber temperature, the chamber pressure, and the time elap3ed in two (2) minute increments during the heat up phase. During the actual Sterilization Phase of the program cycle, the printer will record the chamber temperature, chamber pressure, and the time elapsed for each minute of the program cycle. When the sterilizer has completed the Sterilization Phase of the program cycle, the prirter will print the word VENT to show that the steam pressure was ex- hausted from the chamber. When the: sterilizer has completed the Drying Phase of the program cycle, the word COMPLETE will be printed to show that the sterilizer has completed the sterilization program cycle.