Laserfiche WebLink
4.5.5. Resin coat previously ground mating surfaces on tank sump <br /> with felt roller. Figure 5-2. Fill/vapor Model <br /> 4.5.6. Apply 3 layers of fiberglass layup, saturated with resin,3600 <br /> around tank sump, centered on joint.All layupjoints must <br /> overlap a minimum of 1 in. but not exceed 2 in. in Multiport Watertight Lid <br /> circumferential direction (see Figure 4-3). Hydrostatic Reservoir o <br /> Figure 4-3. Layup Joint w/Electronic Sensor <br /> Enclosure Top <br /> Tank Sump Body Round Body Extension <br /> (Trim From Bottom For <br /> f Field Adjustment) <br /> 4 in. EZ-Fit Adhesive Joints <br /> Grind/Clean Layers of Fiberglass <br /> Mating Surface 3 in. w/Resin 3 in.past Polygon or Round <br /> Each Joint(Kit LK) Tank Sump Body <br /> EZ-Fit Adhesive Joints <br /> 4 in. 3 in. Containment Collar <br /> Grind/Clean <br /> Mating Surface Drain Plug <br /> j — — <br /> Tank sump/collar Tank sump/collar 5.5. Ensure gaskets are installed with the fins angled down away <br /> Exterior Interior g g . Y <br /> 4.5.7. Using the ribbed roller supplied in the kit, hand rollover entire from the lid (see Figure 5-3 and 5-4). <br /> surface of layup,working air bubbles from under the fiberglass <br /> mat, especially around H-clips. Figure 5-3.Tank Sump Gasket <br /> 4.5.8. Allow layup to cure at least hours without moving the joined <br /> parts.The surface of the layup should be hard; if not hard after Wiper Gasket <br /> 5 hours,wait up to 24 hours. <br /> S. ASSEMBLED TANK SUMPS Gasket Fins <br /> Angled Down <br /> Failure to properly test and seal joints may result in Molded <br /> product loss, environmental damage, explosion, or fire. Sump Top <br /> 5.1. All joints must be sealed with our supplied kits. <br /> 5.2. All piping and electrical penetrations (supplied by others) must <br /> seal the tank sump annularspace. <br /> 5.3. Do not connect the tank sump annularspace to any other Figure 5-4.Wraparound Tank sump Gasket <br /> annularspace. <br /> 5.4. Keep the tank sump lid,gasket and gasket groove free from Gasket Fins <br /> contaminates. Angled Down <br /> Figure5-1.Watertight Tank Sump w/Adhesive Joint <br /> Watertight Lid <br /> Hydrostatic Reservoir — Wiper Gasket <br /> w/Electronic Sensor — <br /> Enclosure Top Molded <br /> Sump Top <br /> Round Body Extension <br /> (Trim From Bottom For <br /> Field Adjustment) <br /> EZ-Fit Adhesive Joints 5.6. When installing lid, apply additional lubricant as needed. <br /> Polygon or Round 5.7. If necessary, step on lid perimeter until properly seated. <br /> Tank Sump Body 5.8. NON-WATERTIGHT Tank sump:The lid will fit loosely on the <br /> EZ-Fit Adhesive Joints tank sump top and will not be watertight. <br /> Containment Collar <br /> Drain Plug <br /> Heber Glass Systems I KOY fgssales@nov.com <br />