Laserfiche WebLink
INITIAL SET-UP - H5M <br />H5M <br />5. <br />INITIAL SET-UP - OHW <br />HWZ <br />NORMAL USE <br />OHW <br />46819 O43C127 <br />CAUTION - The dispenser must be disconnected from the power source throughout <br />the initial set-up, except when specified in the instructions. <br />1. Remove the center rear panel and rotate the control thermostat knob fully coun­ <br />terclockwise to the “OFF” position and replace the panel. <br />2. Plug-in the dispenser. <br />3. Water will automatically flow into the tank to the proper level and shut-off. <br />4. Unplug the dispenser, remove the center rear panel and rotate the control ther­ <br />mostat knob fully clockwise to the “ON” position, and replace the panel. <br />Plug-in the dispenser and wait approximately twenty minutes for the water in the <br />tank to heat. The dispenser is ready for use. <br />NOTE - Due to the tank capacity and heater size, this product should be used only <br />for dispensing a few cups of hot water at a time. (Larger capacity Bunn-0- <br />Matic not water dispensers are available.) <br />CAUTION - Water dispensed from this faucet is extremely hot. (Above 200° F.) <br />1. Hold open the faucet whenever a cup of hot water is desired. <br />2. Pour another full pitcher into the top whenever water is no longer available at <br />the faucet. No wait is needed, the faucet is ready to dispense another cup of <br />hot water. <br />CAUTION - The dispenser must be unplugged throughout the initial set-up, <br />except when specified in the instructions. <br />1. Place an empty vessel under the faucet, lift the pour-in lid, and pour a full pitcher <br />(64 oz) of tap water into the top of the dispenser. Hold open the faucet handle <br />to allow air to escape from the tank while it is filling. <br />2. Pour another full pitcher into the top. Close the faucet when water starts flowing <br />from the faucet. <br />3. Fill the top basin with additional water until it is approximately one inch from <br />the top lid. <br />4. Plug-in the dispenser and wait approximately 15 minutes for the water to heat <br />to the proper temperature. <br />5. The dispenser is now ready for use. (refer to the section on normal use.) <br />CAUTION - The dispenser must be disconnected from the power source throughout the <br />initial set-up, except when specified in the instructions. <br />1. Remove the upper rear panel and rotate the control thermostat knob fully coun­ <br />terclockwise to the “OFF" position and replace the panel. <br />2. Connect the dispenser o the power source and turn-on the water supply. <br />3. Water will automatically flow into the tank to the proper level and shut-off. This <br />will take approximately 10 minutes. <br />4. Disconnect the dispenser from the power source, remove the upper rear panel <br />and place the control thermostat knob fully clockwise to the “ON” position, and <br />replace the panel. <br />5. Connect the dispenser to the power source and wait approximately twenty <br />minutes for the water in the tank to heat. <br />6. On models with ready indicator, the indicator will light up when the proper water <br />temperature is achieved. <br />INITIAL SET-UP - HWZ