Laserfiche WebLink
14 46819 043012 <br />WALL MOUNTED INSTALLATION - 5 GALLON MODELS ONLY <br />If the dispenser is wall mounted, the bottom of the dispenser should be at the same height as a counter or <br />table top. Use B.O.M. part #12542.0000 for side mounted Wall Bracket Kit or # 13125.0001 for front mounted <br />Wall Bracket Kit. <br />SUPPORT FOR LARGE RECEPTACLES <br />CAUTION: If the dispenser is to be used with larger receptacles such as pitchers or pots, those receptacles must <br />be adequately supported during dispensing of hot water to avoid spillage of very hot water. This support may be <br />provided by a table or counter top, or use B.O.M. part #12599.0000 Shelf Kit. <br />DRAINING THE DISPENSER - ALL 2, 5 & 10 GALLON MODELS <br />CAUTION - The dispenser must be disconnected from the power source throughout these steps. <br />1. Disconnect the dispenser from the power source. <br />2. Shut-off and disconnect the incoming water supply and allow dispenser to cool. <br />3. Remove the 4-40 screws and the top cover. <br />4. Gently remove one of the grommets from the tank lid. <br />5. Insert a tube to the bottom of the tank and syphon ALL of the water out. <br />DRAINING THE DISPENSER - OHW <br />CAUTION - The dispenser must be disconnected from the power source throughout these steps. <br />1. Disconnect the dispenser from the power source and allow dispenser to cool. <br />2. Tilt dispenser forward over sink. <br />3. Open faucet. <br />4. Continue tilting dispenser forward over sink until water stops flowing. <br />NOTE - The dispenser must be full using the INITIAL SET-UP steps before reconnecting to the power source. <br />CLEANING <br />The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all <br />surfaces on Bunn-O-Matic equipment.