Laserfiche WebLink
PROGRAMMING - H5-ELEMENT Continued <br />LEVEL 2 PROGRAMMING <br />H2 - F° OR C° SELECTION <br />H3 - RESTORING FACTORY DEFAULTS <br />46819 04301213 <br />I3SI <br />SSI3 <br />BSD <br />BHI <br />BBB <br />BBBNOTE: If you release the two buttons at any time before the display reads don, the Fac­ <br />tory Default numbers will not be entered. The old numbers will remain in the memory. <br />1. To enter Level 2 Programming, press and hold the upper hidden button until H2 <br />appears on the display. Release the upper hidden button. The display will show <br />either FAR (Degrees in Fahrenheit) or CEn (Degrees in Centigrade). <br />2. Press and release the (+) or (-) buttons to alternate between FAR and CEn. <br />3. After setting FAH or CEn, to exit Level 2 Programming, press and release the up­ <br />per hidden button twice. Display will show, software version, then main screen. <br />1. To restore Factory Defaults (This clears all settings that were previously entered), <br />press and release the upper hidden button until H2 appears on the display (ap­ <br />proximately 6 seconds). Release the upper hidden Button, then press and release <br />the upper hidden Button once more. The display will read H3, then show (- - -). <br />2. Press and hold both (+) and (-) buttons to initiate the resetting of the factory <br />default settings. The display (- - -) will flash on and off during this time. <br />3. When the factory default numbers are loaded in, the display will stop flashing, <br />then read don (DONE). You can now release the two buttons.