Laserfiche WebLink
Always indicate specific section on sketch if multiple values for material, method of installation, size, or year installed (if year is available) are applicable to a single service. <br />Not intended to be inclusive of all possible symbols. <br />This section is for reference only. <br />E---- Gas Line (New( ® Meter Anode Reducer AOR --0-- EFV —& Valve with Frame and Cover <br />AGas Line (Existing( ® Meter Manifold ® Electronic Marker � Service Tee —D OR —) Cap Pipe Size and Material (Casing Size and Material( Insert <br />Service pipe <br />Service tee <br />Pressure classification: High pressure (HP), <br />semi—high pressure (SHP ), low pressure <br />(LP), transmission pressure (TP) <br />l Mather/branch service <br />l New cathodic protection (e.g. anode) <br />l Abandoned pipe <br />Electronic markers <br />Fittings per TD -4461M <br />Curb valve <br />Excess flow valve <br />l Meter/manifold <br />Pipe casing <br />l Regulating stations involved in or within <br />close proximity to work <br />l Meter guards <br />Milan Or point connection per <br />TD-950OP-14—JAD1 <br />LAN IDr of qualified individual performing <br />connection <br />Material <br />Method of install per <br />TD -4461M: Trench, HER, <br />splitting, dry bare, insert <br />Pipe size <br />Status: New or existing <br />l Existing pipe: Year install <br />if available <br />s Casing material <br />Casing size <br />l Joint trench (JT) <br />Material <br />Type: Main or service <br />Status: New or existing <br />System status, Tied (T) or <br />dead end (DE) <br />l Existing pipe: year installer <br />If available <br />e Casing size <br />. Joint trench <br />. Name of nearest cross street <br />. Name of street <br />• North arrow <br />. Street address <br />. Dimension service tee to service end <br />. Dimension service tee to nearest cross street <br />a Casing length <br />e Abandoned pipe length <br />• Width of cross street <br />e Repairs: Dimension from service tee or riser <br />and length of repair <br />a Partial replacement: Dimension from service tee <br />or riser and length of installation <br />• Stub completion: Dimension from service tee or <br />riser and length of installation <br />e Manifold or large meter: Dimension minimum <br />distance required between structure and riser <br />. Lateral offset: Dimension from service tee or <br />riser <br />. Valves and fittings: Dimension from service tee <br />or riser <br />The following is the minimum information required <br />when documenting abandonments on the GSR. <br />. Location of gas flaw termination <br />• Installed assets related to abandonment (e.g. <br />electronic markers, end caps, plugs) <br />a Abandoned pipe: Length, material, size <br />. Abandoned pipe: Year Installed, if available <br />. Date abandonment work was completed in <br />accordance with TD-950OP-16 <br />. LAN ID and signature* or printed name of the <br />qualified field representative performing <br />required test(s) and/or hapection(s) <br />a LAN ID and signature or printed name" of the <br />person in charge responsible for installing <br />assets and performing work related to <br />abandonment <br />. Excavation Agent: PG&E or Applicant <br />Abandonment order reference <br />Abandoned non—pipe assets, If <br />available, material, size. <br />