Permits & Development - Encroachment(EP)/Driveway(DW) Permits - 2015_PS-1503001 thru PS-1503500_ - PS-1503069

Home Browse Search

Special Conditions for ENCROACHMENT PERMIT -2- 11. Bell Holes shall be maintained in a smooth and even condition to the satisfaction of the County throughout the project limits at all times. 12. All bell holes shall be completely backfilled or shored and plated the roadway restored to two-way traffic. If plating is to be a Plating loadings shall be prepared by a registered civil erg sneer used, at the end of each workday, and County. 9 and submitted for p prior stable for traffic approval by the 13. The contractor shall use San Joaquin County Standard R-29 w County right-of-way. Where the existing road structural section ris below standard,en k standard, a minimum ng bell holes within the f section of 3 inches oasphalt concrete over 8 inches of aggregate base 14. Temporary pavement shall be provided for all bell hole areas wshall be required. ithin three days of pavement removal or by Friday of each week, whichever is more restrictive. 15. Roadway areas subject to pavement cuts shall receive from the centerline (or lane line) to the edge of the travelled way. If th both sides of the centerline (or adjacent la a one (1) inch asphalt concrete overlay bothresusides All pavement conforms shall be ground to pentire a flush e pavement is disturbed on grind and overlay within 10-working days of permanent trench roadway (or affected lanes) shall be brought up to the finish grade as directed by the County. sh surface. Contractor shall paving. Shoulder areas shall be 16. No paving joints allowed within paved shoulder, contractor sh paved shoulder. all pave all the way to outer edge of 17. Contractor shall establish existing roadway and drainagerad Any repair to roadway g es within the construction area. s changes shall receive prior approval from County. g s and adjacent areas shall match existing rade . Any proposed grade 18. School buses shall be passed through the work zone with mi 19. County roads shall be kept clean from mud and debris; a minimal delays. work zone areas during entire project. All standard roadway stripin an be visible, maintained and restored throughout the at times along the access points and construction zone during and nafte thellprojectarly 20. In addition to standard dust control measures, streets ;shall b free of dirt, mud and debris during construction activities. The contractor all rovide needed, street sweeping using a modern mechanical ar vacuum-assisted st eepsweepeaily, or as r. 21. The contractor shall not conduct construction operations in rain or heavy fog conditions.