INSTALL 2003 - Laserfiche WebLink

Home Browse Search

1%/ first-dispenser sump, which has been previously fitted. Push the pipe out of the sump in the same direction A � a - until the mark on the pipe appears outside the sump �rwall, and cut with a hacksaw. Now pull the other end of the pipe completely through the sump until both ends are free. Follow the same procedure for any additional runs of pipe in the system. 77r Step #7: Strip the secondary containment jacket on both ends,following the same procedure used in the first dispenser sump. Step #8: Coat the brass barbs on each swivel fitting �y,, with Loctite 51$ gasket eliminator and lower the riser assembiy into the sump. Position one person on either � '- side of the sump and push each end of pipe through the j� flexible entry boors. Make sure that air test boots are installed on each side. The two piece compression clamp is tightened with 1/2° nuts for the 4 bolt version.The 2 bolt version tightens by Push the pipe onto brass swivel fittings applying pressure threading the bolts directly into the bottom piece of the to both sides equally and moving them back and forth compression clamp which is tapped and threaded. and up and down until both ends are flush with the "O" Continue until compression clamp flanges on both sides ring (if required) at the pipe stops. Now install all two- are in contact. Always take the clamps metal to metal. piece compression clamps on all fittings and tighten. Repeat this procedure until all the piping is installed Continue to fit all runs of piping within all sumpss until within this sump. - they are complete. Step#4:After all risers have been centered, tighten the Step#9: Next, you'll make the final connection at the band clamps on the flexible entry boots. There should tank sump. Lay the pipe across the top of the tank sump be at least 3/4" of secondary containment jacket pro- base (if using the three piece sump) and align with the truding beyond the flexible entry boot inside the sump. pipe stop on the brass swivel, which was previously installed in the discharge piping of the submersible Step #5: Now you are ready to move to the next dis- sump. If you are using a one-piece sump, measure the penser sump in the system. In this dispenser sump, you distance between the sump wall and the pipe stop on the will be installing a tee. Measure across the top of the dis- swivel fitting and mark the pipe. Now cut off any excess penser sump and mark the center point. Now pull the and strip the secondary containment jacket, following slack out of the pipe towards the tanks. the same procedure used on all connections, making sure the air test boots are installed. If the pipe has the Hang a riser pipe assembly inside the sump and center, scuff guard, strip it back so it terminates outside the making sure the brass fittings are facing the entry boos. sump wall. Step #6: With a felt tipped marker, mark the pipe at After all connections are completed in the tank sumps, the pipe stop on the brass swivel fitting closest to the return to the dispenser sumps and install all stabilizer 120