Laserfiche WebLink
"CONY Retrofit Plate" Kit Contents <br />Contents: <br />(1) Pre -abraded Tank -spec FRP panel <br />(1) Bravo Adhesive -Epoxy -Retrofit -Kit <br />(1) Stir stick [NOT SHOWN] <br />(1) 1" chip (paint) brush <br />(1) Emery sanding strip [NOT SHOWN] <br />(1) Large pair nitrile gloves <br />(1) NOTICE label <br />(1) MSDS package [NOT SHOWN] <br />FRP Plate material: <br />UL Listed fiberglass (UL1316 matched) <br />(Material MSDS included in package) <br />The panel is technically the same as <br />a piece of our CUL/US Listed SingleWall <br />sump wall and is nominally 1/4" thick. <br />Image of the <br />NOTICE label <br />Qi, NOTICE1 Qi, <br />THE FIBERGLASS RETROFIT PLATE(S) BONDED WITH EPDXY TO THIS <br />CONY -132000 (UDSCCS) CONVERSION FRAME IS A STATE -AUTHORIZED <br />MODIFICATION PROVIDED BY WAY OF THE PRODUCT INSTALLATION <br />MANUAL AND MANUFACTURER CONTROL. REFER TO THIS PRODUCTS <br />STATE APPROVAL LETTER AVAILABLE AT WWW.SBRAVO.COM / CONV <br />STANDARD KIT SIZES <br />Based on our evaluation of the specific application and site conditions, we have determined two <br />standard kit sizes will apply to a majority of conduit interference issues. They are: <br />CONV-Retrofit-Plate-6x18 6"x18" panel intended for the short ends of the conversion frame <br />CONV-Retrofit-Plate-4x25 4"x25" panel Intended for the long sides of the conversion frame <br />NOTE: Due to the custom nature of each custom conversion frame and application, the fiberglass <br />panels in the CONV-Retrofit-Plate kit may require different dimensions than the sizes listed above. <br />In this case the dimensions of the panel will change on the end of the part number. <br />2 ii-CONV-Retrofit-Plate-12B - 9/24/2012 <br />