COMPLIANCE INFO_PRE 2019 - Laserfiche WebLink

Home Browse Search

FW_1 TEREX Safe Operating Procedure Puncturing of Aerosol Cans 3. The waste container accumulating the aerosol liquid waste is hazardous and must comply with all container requirements. The drum must: a) Be an approved UL listed drum for the waste it is holding. b) Be free of damage. DO NOT use a drum that has any denting, rust or one that cannot maintain a proper seal when closed. c) Must be labeled with a properly filled out Hazardous Waste label. This label at a minimum must include: • Accumulation start date • The words "Hazardous Waste" • Name and address of generator • Hazardous properties • Physical state • Composition d) The label must be legible and shall be replaced if it becomes damaged or faded. e) Container must be on secondary containment if it is within 50' of an exterior door. 5. While the unit is accumulating liquid aerosol waste it is considered Satellite Accumulation and must be managed properly. The requirements are: a) The container be in control of the operator b) At or near the point of generation c) Not greater than 55 gallons d) Have the initial date of accumulation e) Not be held on-site for longer than 1 year from initial accumulation date. When the container has reached the 55 gallon maximum capacity it must be moved to the waste accumulation area within 3 days of being filled and marked with the date the quantity was reached. 6. A spill kit shall be kept by the container. 7. Container shall be inspected weekly to ensure compliance with this program. Maintenance (Note: for instructions on how to replace any items listed below, refer to the product manual. ITEM CHECK REPLACE Lid Gasket Before each use As necessary Safe2Filter Monthly Every 60 daysor600 cans _ Cobalt Points Before each use As necessary Bellow Every 180 days As necessary Operating Clamp Before each use Lubricate regularly with light oil such as 3 -int or WD -40. Page 2 of 2