INSTALL_2013 - Laserfiche WebLink

Home Browse Search

FIBERGLASS DOL E-WALL SUMP INSTALLATION STRUCTIONS D. ASSEMBLED SUMPS FIGURE D-2 FillfVapor Model I Failure to properly test and seal joints may result in t_ product loss, environmental damage, explosion, or fire. Multiport Watertight Lid I 360`Hydrostatic Reservoir *44 Enclosure Top Round Body Extension ASPHYXIATION FIRE EXPLOSION (Trim From Bottom For Field Adjustment) • Dry fit all sump components prior to sealing joints, as outlined In Section B. Field Bonded Adhesive Joints • All joints must be sealed with adhesive or layup Polygon or Round Sump Body material to provide watertight joints. Field Bonded Adhesive Joints • All piping and electrical penetrations(supplied by others)must seal the sump annular space. Containment Collar • Do not connect the sump annular space to any other Test Plug annular space. • Keep the sump lid, gasket and gasket groove free from contaminates. FIGURE D-3 • Install lid and seat gasket for 360 degrees. Flat Bottom Sump FIGURE D-1 Watertight Lid Watertight Lid Model 360° Hydrostatic Reservoir Watertight Lid Enclosure Top 360°Hydrostatic Reservoir Round Body Extension (Trim From Bottom - Enclosure Top For Field Adjustment) Round Body Extension Field Bonded (Trim From Bottom Adhesive Joints For Field Adjustment) Polygon or Round Field Bonded Adhesive Joints Sump Body Polygon or Round Sump Body Test Plug Field Bonded Adhesive Joints Sump Bottom Containment Collar Test Plug ADDITIONAL STEPS FOR FLAT BOTTOM SUMP: • Install tank fitting adapters per the manufacturers installation instructions into the tank. Prepare sump bottom to accept tank fitting adapters. • Before placing sump on tank fitting adapters, place approved backfill between the tank top and transition sump bottom. Ensure there will be no backfill voids under the sump. 6