Laserfiche WebLink
' *itoring System Certification 10 <br />Site Address: 3633 DUCK CREEK DRIVE Date of Testing/Service: 02/21/2007 <br />D. Results of TestinglServicing <br />Software Version Installed <br />Complete the following checklist: <br />19.02 <br />X Yes <br />No <br />Is the audible alarm operational? <br />l` Yes <br />❑ No <br />Is the visual alarm operational? <br />Q Yes <br />No <br />Were all sensors visually inspected, functionally tested, and confirmed operational? <br />Yes <br />❑ No' <br />Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will not <br />interfere with their proper operation? <br />❑x Yes <br />No" <br />NIA <br />If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) operational? <br />Q Yes <br />❑ No . <br />❑ NIA <br />For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br />monitoring system detects a leak, fails to operate, or is electrically disconnected? If yes: which sensors initiate positive <br />shut -down? (check all that apply) 0 SumplTrench Sensors; ❑x Dispenser Containment Sensors. <br />Did you confirm positive shut -down due to leaks alld sensor failure/disconnection? ❑X Yes ❑ No <br />❑x Yes <br />❑ No* <br />Q N/A <br />For tank systems that utilize the monitoring system as the primary tank overfill waming device (i.e.: no mechanical <br />overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank fill points(s) and operating <br />properly? If so, at what percent of tank capacity does the alarm trigger? so <br />Yes* <br />❑X No <br />Was any monitoring equipment replaced? If yes, identify specific sensors, probes, or other equipment replaced and list the <br />manufacturer name and model for all replacement parts in Section E, below. <br />® Yes' <br />® No <br />Was liquid found inside any secondary containment systems designed as dry systems? (check all that apply) FL] Product; <br />® Water. If yes, describe causes in Section E, below. <br />❑x Yes <br />❑ No' <br />Was monitoring system set-up reviewed to ensure proper settings? Attach set-up reports, if applicable. <br />❑X Yes <br />❑ No' <br />Is all monitoring equipment operational per manufacturers' specifications? <br />In Section E below, describe how and when these deficiences were or will be corrected. <br />E. Comments: <br />WATER IN SUMPS AND LUBE OIL SUMP HAD PRODUCT. ALL WAS PUMPED OUT. <br />WIO ANNUNCIATOR WORKS HOWEVER LIGHT DOES NOT BUT LIGHTS WORK ON <br />MONITOR. <br />Page 2 of 3 Based on CA form dated 03101 <br />