Laserfiche WebLink
-s-D, Resalts of Testing/Servicino <br /> v <br /> Software Version Installed: <br /> Co fete the Mowing che&-bst: <br /> es ❑ No* Is the audible alarm rational? <br /> s ❑ Na* is the visual alarm operational? <br /> Y s ❑ No* Were all sensors visually inspezted,functionally tested,and confirmed a eratioaal? <br /> Yes ❑ No* Were all sensors installed at Lowest Doint of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ ;X& If alarms are relayed to a remote monitor-ing station, is all communications equipment (e.g. modem) <br /> N/A operational? <br /> Er Yes ❑ No* For,pressurized piping systems, does the turbine automatically strut down if the piping secondary containment <br /> ❑ N/A monitoring system detects a leak,fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down.? (Check all that apply) ❑ Sump/Trench Sensors; ❑Dispenser Containment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? ❑Yes; ❑No, <br /> Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ❑ NIA mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank. <br /> filloint(s)and operating properly? If so,at what percent of tank capacity does the alarm trigger.? 97 1%, <br /> ❑ Yes' No Was any monitoring equipment replaced? If yes,identify specific sensors,probes,or other equipment replaced <br /> and list the manufacturer name and model for all replacement parts in Section E,below. <br /> ❑ Yesvo Was liquid found inside any secondary containment systems designed as dry systems? (Check all tha:apply) ❑, <br /> Product; 0 Water, If yes,describe causes in Section E,below. <br /> s ❑ No* Was monitoring stem set-up reviewed to ensure 2Lo=settings?Attach set no reports,if applicable <br /> Yes ❑ No* I Is all moni meat operational per manufacturer's specifications? <br /> * In Section E helow,describe haw and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> Page?of 3 03/01 <br /> r <br />