COMPLIANCE INFO 2013-2015 - Laserfiche WebLink

Home Browse Search

• 0 Page 6 of 11 1. PIPING SUMP TESTING Test Method Developed By: ❑ Sump Manufacturer ®Industry Standard ❑Professional Engineer ❑ Other(Specify) Test Method Used: ❑Pressure ❑Vacuum ®Hydrostatic ❑ Other(Specify) Test Equipment Used: See attached testing procedures Equipment Resolution: Sump#Additive Sump# Sump# Sump# Vent Sump Diameter: 24x20 Sump Depth: 32 Sump Material&Manufacturer: Fiberglass Height from Tank Top to Top of 10" Highest Piping Penetration: Height from Tank Top to Lowest n/a Electrical Penetration: Condition of sump prior to testing: Fair POitlnri Of Sump Tested' Above highest Above highest Above highest Above highest PaStepenetration penetration peneftation penetration Does turbine shut down when sump sensor detects liquid(both ❑Yes❑No®NA ❑Yes❑No®NA ❑Yes❑No®NA ❑Yes❑No®NA product and waterp. Turbine shutdown response time Is system programmed for fail-safe ❑Yes❑No®NA ❑Yes❑No®NA []yes❑No®NA ❑Yes❑No®NA shutdown?* Was fail-safe verified to be ❑Yes❑No®NA ❑Yes❑No®NA ❑Yes❑No®NA ❑Yes❑No®NA operational?* Wait time between applying pressure/vacuum/water and starting 30 minutes 30 minutes 30 minutes 30 minutes test: Test Start Time: Initial Reading(RI): Test End Time: Final ReaNThreshold Test Dur15 min 15 min 15 min 15 min Change iRI): Pass/Failriteria: 0.002 0.002 0.002 0.002 Test Re ❑ Pass ❑Fail ❑ Pass ❑F ❑ Pass ❑Was sensr testing? ®Yes❑No❑NA ®Yes❑No❑NA ®Yes❑No❑NA ®Yes❑No❑NA Was sensor properly replaced and ®Yes❑No❑NA ®Yes❑No❑NA ®Yes❑No❑NA ®Yes❑No❑NA verified functional after testing? Comments— (include information on repairs made prior to testing, and recommended follow-up for failed tests) Additive Vent Sump not tested—brine fill If the entire depth of the sump is not tested,specify how much was tested. If the answer to any of the questions indicated with an asterisk(")is"NO"or"NA",the entire sump must be tested. (See SWRCB LG-160)