COMPLIANCE INFO 2013-2015 - Laserfiche WebLink

Home Browse Search

• • Page 7 of 11 7. UNDER-DISPENSER CONTAINMENT(UDC)TESTING Test Method Developed By: ❑UDC Manufacturer N Industry Standard ❑Professional Engineer ❑Other(Specify) Test Method Used: ❑Pressure ❑Vacuum N Hydrostatic ❑ Other(Specify) Test Equipment Used: See attached testing procedures. Equipment Resolution: UDC# 1/2 UDC#3/4 UDC#5/6 UDC#7/8 UDC Manufacturer: UDC Material: Plastic Plastic Plastic Plastic UDC Depth: 37" 37" 28" 28" Height from UDC Bottom to Top 8" 8" 8" 8" of Highest Piping Penetration: Height from UDC Bottom to 4" 4" 4" 4" Lowest Electrical Penetration: Condition of UDC prior to Fair Fair Fair Fair testing: Portion of UDC Tested Above highest Above highest Above highest Above highest penetration penetration penetration Penetration Does turbine shut down when UDC sensor detects liquid(both ❑Yes ❑No N NA [-]Yes❑No N NA ❑Yes ❑No N NA ❑Yes ❑No N NA product and water)? Turbine shutdown response time Is system programmed for fail- ❑Yes ❑No N NA ❑Yes❑No N NA ❑Yes ❑No N NA ❑Yes ❑No N NA safe shutdown?' Was fail-safe verified to be ❑Yes ❑No N NA ❑Yes❑No N NA ❑Yes ❑No N NA ❑Yes ❑No N NA operational?* Wait time between applying pressure/vacuum/water and 30 minutes 30 minutes 30 minutes 30 minutes starting test Test Start Time: 12:14pm 12:21pm 12:14pm Visual Fail Initial Reading(RI): 1.4887 2.5349 1.7485 Test End Time: 12:29pm 12:36pm 12:29pm Final Reading(RF): 1.4886 2.5349 1.7485 Test Duration: 15 min 15 min 15 min 15 min Change in Reading(RF-RI): 0.00010 0 0 Pass/Fail Threshold or Criteria: 0.002 0.002 0.002 0.002 Test Result: N Pass ❑ Fail 1 N Pass ❑Fail N Pass ❑ Fail ❑ Pass N Fail Was sensor removed for testing? NYes❑No ❑NA I NYes❑No LINA NYes❑No❑NA NYes❑No❑NA Was sensor properly replaced and NYes❑No❑NA NYes❑No[_]NA NYes❑No❑NA NYes❑No❑NA verified functional after testing? Comments— (include information on repairs made prior to testing, and recommended follow-up for failed tests) UDC 7/8—hole in test boot on 87 sec line 2.7x2.7 i If the entire depth of the UDC is not tested,specify how much was tested. If the answer to any of the questions indicated with an asterisk M is"NO"or"NA",the entire UDC must be tested. (See SWRCB LG-160)