Laserfiche WebLink
D. Results of Testing/Servicing <br /> • C E T Dispatch ' <br /> Software Version Installed: <br /> Com tete the follo ng checklist: <br /> Zr-Yes ❑ No* Is the audible alarm operational? <br /> Yes ❑ No* Is the visual alarm o erational? <br /> t❑ Yes U No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g. modem) <br /> a N/A operational? <br /> 'Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the piping secondary containment <br /> D N/A monitoring system detects a leak fails to operate, or is electrically disconnected? If yes: which sensors initiate <br /> positive shut-down? (Check all that apply) M-Sump/Trench Sensors; ®-Dispenser Containment Sensors. <br /> Did you confirm ositive shut-down due to'leaks and sensor failure/disconnection? ❑Yes; ❑No. <br /> ❑ Yes [ll Ne* For tank systems that utilize the monitoring system as the primary tank overfill warning device (i.e. no <br /> ❑ No* mechanical overfill prevention valve is installed), is the overfill warning alarm visible and audible at the tank <br /> fill point(s)and.operating roperly? If so,at what percent of.tank ca acity does the alarm triuip <br /> � ecific sensors,probes, or other equipment replaced <br /> Yes* ❑ No Was any monitoring equipment replaced. If yes,identify specific <br /> and list the manufacturer name and model for all replacement arts in Section E,below. <br /> ® Yes* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑ <br /> Product; ❑ Water. If yes,describe causes in Section E,below. <br /> L! Yes ❑ No* Was monitoring system set-up reviewed to ensure proper settin s?Attach set u reports,if applicable <br /> U Yes ❑ No* Is all monitoringequipment operational per manufacturer's s ecifications? <br /> * In Section E below,describe how and when these deficiencies were or will be toss ected. <br /> E. Comments• n e s" t <br /> IC�F 2 <br /> Z v e r o <br /> Page 2 of 3 <br />