Laserfiche WebLink
r Patents Pending <br /> i <br /> Pipe & Conduit EntriesN, .x° . <br /> #fn. <br /> Flexible Entry Boots <br /> All pipe and conduit entries Into the dispenser sump wall are sealed by using the water-tight Flexible Entry Boot. Each size boot consists of a flexible rubber boot <br /> which encapsulates a studded flange,a compression ring,fasteners and band clamp. These rubber seals are available in the following sizes:112",314",and 1" <br /> conduit slzes;1-112", 2",3",3-1/2"-and 4"pipe sizes. The following installation procedures should be followed for proper installation. <br /> i n <br /> 112" 314" 1" 1-112" 2" 3" 3 3-1{2" 4" B" <br /> Step#1 S16" Bit Step#2 <br /> Locate the center entry point in / After the bolt hole circle has been <br /> the flat wall section of the J drilled, drill out the entry boot <br /> dispenser sump and drill a 516" opening by using the appropriate <br /> hole. Install the Entry Boor size hole saw. <br /> Templet l to the sump base wall <br /> using a 114"bolt and nut. Qrifl out Hole Saw Flexible Entry Boots <br /> the appropriate bolt hole circle for2.1/4^ 112",314",1"&1-112" <br /> the size boot to be installed using a v2" 2"&3" <br /> the same 5116" drill bit. After Fastener <br /> drilling remove the templet from 5-112•' 3-1/2"&4" <br /> the sump wall. After drilling out opening, clean <br /> Entry Boot any rough edges with a razor <br /> Templet knife. <br /> Step#3 i Step#4 <br /> Install the rubber boot from Using a 7/16" nut driver, tighten <br /> outside the sump by inserting the I�tsq all of the nuts evenly and firmly. <br /> studs through the bolt holes. To prevent deforming boots do <br /> From Inside of the dispenser not over tighten nuts. If a torque <br /> sump,install the compression ring wrench is used,the setting should <br /> over the studs and tlghten nuts by be 60 in.lbs ; <br /> hand. <br /> Step#5 Band Clamp Angled Entries <br /> Insert the appropriate sized pipe f The flexible entry boot is flexible <br /> or conduit into the flexible boot l/ enough to permit angled pipe or <br /> from outside of the dispenser conduit entries up to a 30' angle. <br /> sump. After the pipe or conduit Angles greater than 30' could <br /> has been positioned, install the `{ prevent the boot from sealing <br /> band clamp around the boot and n around the pipe or conduit. <br /> tighten to 60 in.lbs. <br /> 5 <br />