Laserfiche WebLink
Introduction <br /> Polyriite Dispenser Sumps <br /> Environ offers a line of dispenser sumps which are designed to - - --- - <br /> prevent fuel leaks and filter spills from escaping into the environment o 00 <br /> underneath fuel dispensers. They provide a means of liquid tight o n 8 o <br /> entry for both single and double wall conventional and flexible pipe, o s' <br /> o ' Oi Oo 0 <br /> as well as electrical conduit. They allow for easy insrallation in both ° 00 <br /> ° '000 0 <br /> new and relrobt construction applications. A variety of optional 0 <br /> accessories are available to meet your design specifications. . 0 <br /> iono° _ -0 $ <br /> 0 0; 00 0 0 <br /> °00 O ° o O <br /> 0 p 0 O 0 0 00. <br /> Dispenser Sump Features <br /> • Liquid Tight Dispenser Sump <br /> • Fully Adjustable Stabilizer Bar <br /> • Uses Flexible Entry Boots <br /> • Non-corrodible Polyethylene Sump <br /> • Installs in both new and retrofit installations <br /> • Accommodates single and double wall pipe <br /> • Height adjustable riser section <br /> • Remote draining capabilities <br /> General Information <br /> This product manual is designed to provide the recommended installation procedures and requirements for PolyTite Dispenser Sumps. Failure to comply with <br /> these instructions and specifications shall void the product warranty. When ordering dispenser sumps make sure to specify the optional components required to <br /> accommodate the designed installation. <br /> D Standard Features <br /> I E Dispenser sumps are available with the following standard and <br /> B _' accessory components: <br /> ��-C <br /> H A-Molded Polyethylene Sump <br /> F B-Steel Mounting Frame <br /> C-6"Anchor Bolts w/Fasteners <br /> -'� D - End Plates w/ Fasteners <br /> A E-Side Struts <br /> F-3/8"Anchor Nuts <br /> G- Flexible Entry Boots (Accessory) <br /> ��\\\ <br /> G H -Adjustable Support Bracket <br /> I -Stabilizer Bar Kit (Accessory) <br /> Standard Dispenser Sumps Custom Dispenser Sumps <br /> These Standard Dispenser Sumps can be field customized to accommodate These dispenser sumps are available with factory installed Flexible Entry <br /> both flexible and non-flexible piping systems,as well as a variety of different Boots in prescribed locations to accommodate both Flex I and Flex d piping <br /> dispenser models. The appropriate type and number of Stabilizer Har Kits systems. There are two types of custom sumps,they are Junction Dispenser <br /> and Flexible Entry Boots, used for both pipe and conduit entries, must be Sumps and Terminating Dispenser Sumps,which are available in a variety of <br /> ordered additionally. models to fit most dispensers, <br /> Index <br /> Introduction & Index............................................................1 Flexible Connector Isolation.................................................6 <br /> Specifying Accessory Components....................................2 Automatic Shut-off Devices.................................................7 <br /> Pre-installation Assembly.....................................................3 Dispenser Sump Draining...................................................B <br /> Specifying Shear Valves...................................................3 Dispenser Sump Monitoring..................................................8 <br /> Island Installation............. ....4 Remote Draining System................................................... <br /> Pipe & Conduit Entries.....................................................5 Specification Checklist.......................................................10 <br /> Stage 11 Pipe Entries.............................................................6 Guide Specifications & Warranty.....................................Back <br />