Laserfiche WebLink
Facility Information <br />The Libbey-Owens-Ford Co. (LOF) manufacturing facility is situated <br />in the City of Lathrop and fronts Louise Avenue, a major east/west <br />route through the City of Lathrop. In 1986, a 5,000 gallon <br />underground storage tank was installed on the north side of the <br />facility adjacent to the cap and cut area (see Figure 1) The tank <br />holds gasoline which is used in forklifts. <br />Underground Tank Monitoring Equipment <br />Monitoring of the underground tank is accomplished by the use of a <br />Veeder-Root TLS -250 tank level sensor system. The monitoring <br />system allows for on -demand inventory reporting as well as the <br />ability to detect leaks via leak detection reports and leak alarm. <br />Information is supplied via a digital readout and/or a print-out. <br />The monitoring equipment is wall mounted and located in the quality <br />control office, approximately 200 feet south of the underground <br />tank (see Figure 1). <br />Monitoring Procedure <br />To monitor the tank, LOP personnel check the Veeder-Root TLS -250 <br />daily, Monday - Friday. The equipment is checked to determine if <br />it is operating correctly. The monitoring equipment allows for <br />manual override to check hardware and software. At the end of the <br />inspection, the results are entered into a log maintained adjacent <br />to the equipment. At the end of the month when tank inventory is <br />taken, the log is collected and placed with the inventory <br />paperwork. <br />Monitoring and maintenance of the monitoring equipment is the <br />responsibility of the electricians assigned to the maintenance <br />department. Assigning these tasks to the maintenance department <br />allows for immediate response to any problems associated with the <br />monitoring equipment including the repair of the equipment. The <br />supplier of the monitoring equipment is also available to assist in <br />trouble shooting any problems. Preventive maintenance of the <br />monitoring equipment will in accordance to the manufacturer's <br />instructions. <br />