COMPLIANCE INFO_2008-2009 - Laserfiche WebLink

Home Browse Search

Executive Order VR-202-D Healy Phase 11 EVR System Including Veeder-Root ISD System Exhibit 3 Part 1 - Healy Manufacturing Performance Standards and Specifications The Healy Phase II EVR System Including Veeder-Root ISD and all components shall be manufactured in compliance with the performance standards and specifications in CP-201 (amended May 25, 2006), as well as the requirements specified in this Executive Order. All components (Exhibit 1) shall be manufactured as certified; no change to the equipment, parts, design, materials or manufacturing process shall be made unless approved in writing by the Executive Officer or Executive Officer delegate. Unless specified in Exhibit 2 or in the ARBApproved Installation, Operation and Maintenance Manual, the requirements of this section apply to the manufacturing process and are not appropriate for determining the compliance status of a gasoline dispensing facility. 1. NOZZLES Every nozzle shall be tested at the factory. Every nozzle shall have affixed to it a card or label stating the performance specifications listed below, and a statement that the nozzle was tested to, and met, the following specifications. a. The nozzle vapor valve leak rate shall not exceed 0.038 cubic feet per hour(CFH) at a pressure of+2 inches H2O when tested in accordance with the latest version of TP-201.2B. b. The nozzle vapor valve leak rate shall not exceed 0.10 CFH at a vacuum of-100 inches H2O when tested in accordance with the latest version of TP-201.28. C. The nozzle automatic shut off feature is tested at all service clip settings (either two or three) as well as handheld in accordance with Underwriters Laboratories (UL) Standard 842. d. The nozzle is tested in accordance with the California Department of Food and Agriculture Division of Measurement Standards Article 2 (DMS 6-6- 97). Healy Phase 11 EVR System Including Veeder-Root ISD, Exhibit 3—VR-202-D