Laserfiche WebLink
46 4 <br /> 7 Software Overview <br /> Scripting Levels <br /> The pH Control scripting levels provides a simple means of adjusting the unit's internal settings, <br /> testing pumps, as well as calibrating the probe. <br /> Note: o access the Scriptingpress and hold for , , <br /> Qv <br /> RECORD DOWNLOAD SAMPLE <br /> pH-Control Product name <br /> Meta Rev...................................................1.1 EPROM version number <br /> Serial No..........................NUSD000OOOO-00 Serial Number <br /> Sample Rate...........................................33% Percentage of batches tested for pH <br /> PH Alarm................................................ON pH Alarm On or Off <br /> Frequency............................................60Hz 66Hz or 50Hz <br /> Dev/Neutr.Ratio............................5.9 to 1 Ratio Neutralizer to developer <br /> TL Count..........................................00000 L Total Liter Count <br /> TN Count.........................................00000E Total Neutralizer Count <br /> Date TL TN pH Alarm bete,Total Liters treated/day, <br /> 25/10 OOOL OOOL pH 7.5 Power On Total Neutralizer/day.pH reading <br /> 24/10 OOOL OOOL pH 7.5 Power On and service alarms <br /> tt tt <br /> cursor will appear under the selection to be altered. <br /> 'Ilie 0 will increase the desired value,and the (9 will <br /> decrease the value.Pressing® will select the desired value <br /> and advance the cursor to the next value to be changed.This <br /> process is repeated until no characters are left to be altered. <br /> Select"Y"to activate the DEV and WATER PUMPS. <br /> This will initiate a 5 minute pumping cycle to verify the <br /> pumping action of the bellows pump. <br /> To stop the Force Dev/H20 mode,press the Q key. <br /> Page 12 Metafix pH Control Manual <br /> J <br />