COMPLIANCE INFO_2018 - Laserfiche WebLink

Home Browse Search

D. Results of Testing/Seryicing Software Version Installed: 120.02 Complete the following checklist: ❑X Yes ❑No* Is the audible alarn►operational? ❑X Yes ❑No* is the visual alarm operational? ❑X Yes ❑No* Were all sensors visually inspected functionally tested,and confirmed operational? ❑X Yes ❑No* Wo ere all sensors installed at lowestpoint of secondary containment and positioned so that other equipment ll not interfere with their pr per o peration? ❑ Yes ❑No* If alarms are relayed to a remote monitoring station,is all communications equipment(e.g.modem) ❑X N/A operational? ❑X Yes ❑No* For pressurized piping systems,does the turbine automatically shut down if the piping secondary ❑N/A containment monitoring system detects a leak, fails to operate,or is electrically disconnected?If yes:which sensors initiate positive shut-down'?(Check all that apply) ❑X Sump/Trench Sensors; ❑X Dispenser Containment Sensors. Didyou confirm positive shut-down due to leaks and sensor failure/disconnection'? ❑x Yes; ❑N o. ❑X Yes ❑No* For tank systems that utilize the monitoring system as the primary tank overfill warning device(i.e.no mechanical overfill prevention valve is installed),is the overfill warning alarm visible and audible at the ❑N/A tank till point(s)and operating properly?If so, at what percent of tank capacity does the alamt trigger? 90 % ❑Yes* ❑X No Was any monitoring equipment replaced?If yes,identify specific sensors,probes,or other equipment replaced and list the manufacturer name and model for all replacement parts in Section E,below. ❑Yes* No Was liquid found inside any secondary containment systems designed as dry systems? (Check all that apply) ❑Product; ❑Water.If yes,describe causes in Section E, below. ❑X Yes ❑No* Was monitoring system set-up reviewed to ensure proper settings?Attach set up reports,if applicable ❑X Yes ❑No* Is all monitoring equipment operational per manufacturer's specifications? *In Section E below,describe how and when these deficiencies were orwill be corrected. E. Comments: Other From Section B: L11:Waste oil overfill sensor 794390-420 certified. L15:Vent transition sump sensor 794380-208 certified. L16:Waste oil pan sensor 794380-208 certified. From Section D:Waste oil tank overfill system electronic solenoid shuts down flow to the tank at the waste oil drain pan. Unleaded and Diesel tank have a mechanical drop tube overfill prevention valve as primary overfill.