Laserfiche WebLink
**4.4.1.2 On- tape coated pipe, repairs should be made anytime <br /> the inner wrap is exposed. If both the inner and <br /> outer wrap is- damaged, a double layer of patch <br /> material _Woint Trap) should be applied to the <br /> damaged area. <br /> MISCELLANEOUS <br /> 5.1 Do not leave rolls of tape in direct sunlight for long periods of <br /> time. Tape should be left in cartons and remain under cover until <br /> 1 ready to use. Protect from dust, dirt, and other. contaminates. <br /> `= 5.2 If tape is back rolled before use, special care shall =.be`ex remised <br /> to keep foreign matter from clinging to the adhesive 44_0f. t <br /> ham,,. <br /> tape. (Polyken 930 only.f'-Tape with release' paper'can be track <br /> rolled only if the-release paper is removed. Failure to do so wi_11 <br /> result in self adhesion between the mastic-and backing. f <br /> 5.3 ' Primer cans should be kept covered to prevent evaparatibn-and drying <br /> of the primer and to keep out dirt and other foreign matter. After <br /> use, brushes may be wrapped in wax paper so- that they are kept as <br /> clean as possible. Stiff brushes will soften when fresh primer is <br /> applied. <br /> 5.4.._.To facilitate removal of primer from the skin, industrial skin <br /> protection paste (Ply No. 1) should be thoroughly rubbed on the <br /> • --hands and forearms before handling the primer. =- <br /> --I <br /> 5.5 -',Avoid skin contact with the primer solvent. If accidental contact <br /> -is made. remove with approved waterless hand cleaner or abrasive <br /> :h .. <br /> hand soap and water as soon as possible. Gloves should be worn <br /> where contact cannot be avoided. <br /> 5.6 Avoid breathing primer vapors.' Primer should be used in a well <br /> .ventilated area. when primer must be applied in a poorly ventilated <br /> area, wear a. respirator with-aa organic vapors cartridge. (see - <br /> Section- 7.&Y. <br /> xfi. <br /> 5.7 Solvent, primer, and their vapors are volatile and flammable. Keep <br /> away from sources of ignition. Tape wraps shall not-.be—removed by <br /> dissolving with solvents. - <br /> 1 5.8 Use wrap only for buried facilities. If fac�ll- ty eitbnds above <br /> ground, wrap should extend 6" above ground level. Direction of wrap <br /> should be from exposed portion to buried port/on. This prevents <br /> wrap from unwinding. Coat facilities which are aboveground or in <br /> vaults with proper coating from Standards in E-30 Section. <br /> **Paragraph added. <br /> • ­-P G 3 E CO. AAWIXG NUM v. <br /> 6 <br /> EV 6 of 9 SHEETS 086509 <br /> ' <br />