Laserfiche WebLink
4.5.7. Using the ribbed roller supplied in the kit,hand roll 5.1. All joints must be sealed with C51 supplied kits. <br /> over entire surface of layup,working air bubbles from 5.2. All piping and electrical penetrations(supplied by <br /> under the fiberglass mat,especlally around H-clips. others)must seal the tank sump annular space. <br /> 4.5.8. Allow layup to cure at least 5 hours without moving 5.3. Do not connett the tank sump annular space to any <br /> the joined parts.The surface of the layup should be other annular space. <br /> hard;if not hard after 5 hours,wait up to 24 hours. <br /> 5.4. Keep theta lid,gasket and gasket groove free <br /> a from contaminates.irate& <br /> I 5.5. Ensure gaskets are installed with the fins angled down, <br /> away from the lid(see Figure 5-3). <br /> Failure to property test and seal Joints may mi In product lose, Figure 5-3 <br /> environmental damage,explosion,or fire. <br /> Tank sump Gasket <br /> Figure 5-1 <br /> Watertight Tank sump w I Mhesive Joint Wiper Gasket <br /> Watertight Lid ----T <br /> Gasket <br /> glMFinDewn <br /> Hydrostatic Reservoir _____J <br /> EnclosureTop Molded <br /> SumpTop <br /> Round Body Extension <br /> (Trim from Bottom for <br /> Field Adjustment) ' <br /> EZ-Flt Adhesive Joint 5.6. When installing lid,apply additional lubricant as needed. <br /> S.7. If necessary,step on lid perimeter until properly seated. <br /> Polygon ofRound 5.8. NON-WATERTIGHT Tank sump:The lid will fit loosely on <br /> Tank Sump Body the tank sump top and will not be watertight. <br /> EZ-Fit Adheaveloint <br /> :a s <br /> Containment Collar_ <br /> Drain Plug Figure 61 <br /> Flat Bottom Tank sump <br /> Figure 54 Watertight Lid <br /> Fiy/Noy Model Hydrostatic Reservoir <br /> EnclosureTop <br /> Round Body Extension <br /> (Trim From Bottom for <br /> -- Field Adjustment) <br /> MultiportWatertight Lid _ EZ-Flt Adhesive Joint <br /> Polygon or Round <br /> Hydrostatic Reserroir Tank Sump Body <br /> Dain Plu <br /> Enclosure Top Tank Sump Botto <br /> Round Body Extension Tank Mounted Fitting <br /> (Trim from Bottom for w/Sump Adapter <br /> Field Adjustment) Tank Wal <br /> EZ-Fit Adhesive Joint 6.1. Follow all tank sump instructions in sections l-5 for <br /> Polygon Round 'i properly assembling a tank sump. <br /> Tank Sump Body 6.2. All joints must be sealed with CSI supplied kits. <br /> EZ Fit Adhesive Joint 63. Install tank fitting adapters per the manufacturers <br /> Installation instructions Into the tank.Prepare tank sump <br /> Containment Collar, bottom to accept tank fitting adapters. <br /> Drain Plug <br /> 6 <br />