Laserfiche WebLink
Executive Order VR-101-D Phil-Tite Phase I Vapor Recovery System <br /> Exhibit 3 <br /> Manufacturing Performance Standards and Specifications <br /> The Phil-Tite system and all components shall be manufactured in compliance with the <br /> performance standards and specifications in CP-201, as well as the requirements specified in <br /> this Executive Order. All components shall be manufactured as certified; no change to the <br /> equipment, parts, design, materials or manufacturing process shall be made unless approved in <br /> writing by the Executive Officer. Unless specified in Exhibit 2 or in the ARB approved <br /> Installation, Operation and Maintenance Manual for the Phil-Tite Phase I Vapor Recovery <br /> System, the requirements of this section apply to the manufacturing process and are not <br /> appropriate for determining the compliance status of a GDF. <br /> Pressure/Vacuum Vent Valves for Storage Tank Vent Pipes <br /> 1. Each PressureNacuum Vent Valve (PN valve)shall be 100 percent performance tested at <br /> the factory for cracking pressure and leak rate at each specified pressure setting and shall <br /> be done in accordance with TP-201.1 E, Leak Rafe and Cracking Pressure of <br /> PressureNacuum Vent Valves. Each PN valve shall be shipped with an card or label <br /> stating the performance specifications listed below, and a statement that the valve was <br /> tested to, and met, these specifications. <br /> a. The pressure settings for the PN valve <br /> Positive pressure setting of 3.0 ± 0.5 inches H2O. <br /> Negative pressure setting of-8.0± 2.0 inches H2O. <br /> b. The leak rate for each PN valve, including connections, shall not exceed: <br /> 0.05 CFH at 2.0 inches H2O. <br /> 0.21 CFH at-4.0 inches H20- <br /> 2. Each PN valve shall have permanently affixed to it a yellow or gold label with black <br /> lettering listing the positive and negative pressure settings specified above. The lettering of <br /> the label shall have a minimum font size of 20. <br /> Rotatable Product and Vapor Recovery Adaptors <br /> 1. The rotatable product and vapor recovery adaptors shall not leak. <br /> 2. The product adaptor cam and groove shall be manufactured in accordance with the cam <br /> and groove specifications shown in Figure 3A of CP-201. <br /> 3. The vapor recovery adaptor cam and groove shall be manufactured in accordance with the <br /> cam and groove specifications shown in Figure 3B of CP-201. <br /> 4. Each product and vapor recovery adaptor shall be 100 percent performance tested at the <br /> factory for static torque, rotatability, and the absence of liquid or vapor leaks. Each <br /> adaptor shall have affixed to it a card or label stating the performance specification listed <br /> below, and a statement that the adaptor was factory tested to, and met, the following <br /> specifications: <br />