INSTALL_2007 - Laserfiche WebLink

Home Browse Search

Vacuum Sensor System Installation Guide Vacuum Integrity Test Prior to Filling Tank(Optional) Press STEP to continue.: s 1: (Vacuum Label) RELIEF VALVE PRESSURE:-9.0 Enter the pressure at which the installed Relief Valve is rated to open (the vent pressure is stamped on the body of the V-R Relief Valve).The permitted range is-5 to-9 psi. Default vent pressure is-9 psi. Press ENTER to confirm your entry. Press Tank/Sensor to setup another Vac Sensor. Vacuum Integrity Test Prior to Filling Tank (Optional) Skip to'Running a Manual Test' if this optional test is not going to be performed. If an external vacuum source is not used to produce a vacuum in the monitored zones prior to startup,you must perform a'Manual Test'on each sensor to clear the'No Vac' alarm. A procedure to test the integrity of the interstitial spaces monitored by the Veeder-Root Vacuum Sensor system is discussed in this section.An external vacuum source and necessary fittings must be supplied by the customer. Before beginning this procedure all vacuum sensor components in the sump must be installed as described in this manual and be connected to a SmartSensor module in the TLS Console. 1. Shut off, tag,and lock out power to the pump. 2. At the TLS Console,configure each of the monitored Vac Sensors in the sump (ref.TLS-3XX Setup Manual). Go to the SmartSensor Diag and place each of the monitored Vac Sensors in EVAC HOLD (ref.TLS-3XX Troubleshooting Manual). 3. At the 3-way ball valve in the cap of the tank's interstitial riser, remove the tubing going to the Vac Sensor from the fitting in the 3-way ball valve and connect the external vacuum source to the fitting.With the valve open to the external vacuum source, pull a vacuum down to-8 psi,or if a relief valve is present,down to 1 psi above the relief valve's opening pressure (e.g., if valve opens at-7 psi, pull the vacuum down to-6 psi). 4. When the desired vacuum is attained,move the 3-way ball valve to the other position. Remove the external source from the valve's fitting and reconnect the tubing to the Vac Sensor. Move the valve back to the'normal' position. 5. If necessary, repeat this procedure for the product line's interstitial space,the vapor line's interstitial space and the double-wall sump's interstitial space. 6. With all of the monitored interstitial spaces under vacuum,at the TLS Console,stop the EVAC HOLD for each Vac Sensor.After a minimum wait of 12 minutes,monitor the Leak Rate and Time to No Vac display for each Vac Sensor.Record the displayed values for each of the sump's vac sensor in the chart in Appendix B. As a general guideline,the Time to No Vac should ideally be 100 hours,and should not be less than 24 hours (a time less than 2 hours will produce an alarm).Also,a Leak Rate greater than 22.4 gph will generate a Vacu- um Warning. Both of these diagnostics are indicators of whether the system has a significant vacuum leak. Note that on systems with small volumes,a very small leak rate,well below the 22.4 gph limit, may still cause a Time to No Vac alarm. If either diagnostic exceeds the guideline,the source of the leak should be corrected before the system is started up.Once the leak(s) is corrected, repeat steps 2-6. 7 When the monitored interstitial spaces under vacuum are within normal operating limits as described in Step 6,fill the tank. 8. Once the tank is full, restore power to the pump. 23