Laserfiche WebLink
Monitoring System Certification is <br /> • <br /> D. Results of Testing/Servicing <br /> Software Version Installed: 329.01 <br /> Com tete the followina checklist: <br /> ® Yes ❑ No* Is the audible alarm operational? <br /> ® Yes ❑ No* Is the visual alarm operational? <br /> ® Yes ❑ No* Were all sensors visually inspected,functionally tested,and confirmed operational? <br /> ® Yes ❑ No* Were all sensors installed at lowest point of secondary containment and positioned so that other equipment will <br /> not interfere with their proper operation? <br /> ❑ Yes ❑ No* If alarms are relayed to a remote monitoring station, is all communications equipment (e.g., modem) <br /> ® N/A operational? <br /> ® Yes ❑ No* For pressurized piping systems, does the turbine automatically shut down if the pij <br /> condary contaimnent <br /> ❑ N/A monitoring system detects a leak, fails to operate, or is electrically disconnected? Iwhich sensors initiate <br /> positive shut-down? (Check all that apply) ®Sump/Trench Sensors; ❑Dispenserinment Sensors. <br /> Did you confirm positive shut-down due to leaks and sensor failure/disconnection? s; ❑No. <br /> ❑ Yes ❑ No* For tank systems that utilize the monitoring system as the primary tank overfing device (i.e., no <br /> ® N/A mechanical overfill prevention valve is installed), is the overfill warning alarm visd audible at the tankfill point(s)and operating properly? If so,at what percent of tank capacity does the trigger? _%E Yes* ❑ No Was any monitoring equipment replaced? If yes,identify specific sensors,probes, er equipment replacedand list the manufacturer name and model for all replacement parts in Section E,bel❑ Yes* ® No Was liquid found inside any secondary containment systems designed as dry systemheck all that apply)❑Product; ❑Water. If yes,describe causes in Section E,below. <br /> system set-up reviewed to ensure proper settings?Attach set up repf applicable <br /> ® Yes ❑ No* Is all monitoring equipment operational per manufacturer's specifications? <br /> * In Section E below,describe how and when these deficiencies were or will be corrected. <br /> E. Comments: <br /> REPLACED TLS-350 BATTERY <br /> MONITOR LOST POWER WHEN OPENING/POWER/PRINTER DOOR- TLS-350 WOULD NOT COMEBACK UP <br /> PERFORMED COLD START AND SET UP AND ALL SENSORS CONFIRMED CORRECT <br /> Page 2 of 4 <br /> UN-036- www.unidoes.org Rev.01/17/08 <br />